Replaced the 2 clutches on vertical transports of both machines.. They came with a smaller clutch than book shows/ different part number. Had 3.5w clutches and replaced with the correct ones that...
Type: Posts; User: CPI
Replaced the 2 clutches on vertical transports of both machines.. They came with a smaller clutch than book shows/ different part number. Had 3.5w clutches and replaced with the correct ones that...
I think you have to have EPROM / IC-208 added to pwb for printing
Sent from my Z930L using Tapatalk
You can try going to service to developer and OK to start and press OK again to stop has worked before.
Sent from my Z930L using Tapatalk
We got 2 of these "302GR44120 CLUTCH FEED" ordered to replace on the VERTICAL FEED UNIT. Seems to be the only solution suggested so far.
could be the black plastic grid on the transfer/ separtion corona is not completely seated and scratching the drum.
Jam code 61. Kyocera says also to replace conveyance clutch for possible too much grease on clutches from factory.
Sent from my Z930L using Tapatalk
Plain paper or thick? you can up fuser temp if it's ghosting from fuser. Or set as thick paper.
2 Brand new 9530's with PF-750 duplex jams- All trays including PF-750 large capacity tray feed single side with no problems. Trays 1 and 2 duplex with no jamming. Tray 3 / PF750 jams when duplexing...