on these mp2851 mp3351 if you remove the back panel you will see there is a small switch that gets activated when you slide the cassette in. they are bad for coming loose and not reading correctly....
Type: Posts; User: tnelson
on these mp2851 mp3351 if you remove the back panel you will see there is a small switch that gets activated when you slide the cassette in. they are bad for coming loose and not reading correctly....
yes the one way gears on these mp6001 doc feeders need to be cleaned quite often. clean the bearings with alcohol and clean the shafts lightly with emery cloth or scotch brite. pay close attention...
with the 03 series you can no longer get individual developer. you have to install dev units just like the old c2050 series.
i had the same type of issue on prints only on a c3502. ricoh tech support had me run 5801-8. printer memory clear and the issue stopped. hope that helps.
you said he is using glossy paper from the bypass. what media setting is he using? thick 1,2,3 etc? it looks like it might not be fusing cleanly thus giving that splotchy density look. just a...
if you have to you can do sc5801 all clear reset. its always the last thing if you have tried everything else.
what is your developer count at. those codes are usually the warning signs that your developer is finished. as for your jamming issue in the df ... clean all the one way gears in the back of the...
i agree, betting its not the correct controller. if the part# isn't D092-5724 you've got the wrong one! nothing you do will change the 995 code.
i know the color copiers (c2000 c2500 c3000 c2800 c3300) have issues like this. the polygon motor in the laser malfunctions and takes out the bicu. i have had to replace these as a set multiple...
ok ... by main board do you mean the controller or the bicu?
agreed, you've just got to love the 03 series!! NOT!! lol
you can also check sm 5985-1 and -2. both should be set to 1 and not 0. if 5985-1 is set to 0 that is why you can't access wim. it resets to 0 if you have to nvram it or at times if you do an all...
yes that looks like an itb cleaning failure alright!! i would be replacing that unit. very easy to replace.
by engine board do you mean the bicu? if so did you remember to swap the little eprom chip. if you didn't that may explain your issue.
enter service mode, then hold the number key down and press system sp. you are in special mode!! hope that helps
to use the b224-2042 pcu on an 02 series you must first break off the metal pins at the back of the machine. we built a little tool for this but i have had to do it with just pliers. if you shine a...
when you remove the reg guide, there is a mylar adhered to the back of it. i have seen that get damaged and start hooking the page as it goes by. doesn't damage it enough to jam but nicks the page...
when you take the itb out flip it over and have a good look along the edge. we have had alot of them tear along the rear edge, then when it goes by it creates a bump mark. just food for thought.
yes i'm pretty sure he was talking about the bicu that you have to replace along with the poly motor. black screen with sc202 code showing in the background. c2000, c2500, c3000, c2800 and c3300. ...
just a quick question ... you didn't happen to have had the nv ram / counter chips out of this machine? if you put them back in without matching up the notches this will happen. machine will sit in...
yes the duplex guide warps, the new style have a metal bracket to help keep it for warping. there is also a new style exit assembly itself available as the guides in it warp/crack and break.