No! Don't!
That Will just scratch the roller!
Fold a sheet of paper into 8. Using the shortest edge, scrape it against the roller (if it's black!). Vacuum the roller to get rid of the debris. If...
Type: Posts; User: tcs04
No! Don't!
That Will just scratch the roller!
Fold a sheet of paper into 8. Using the shortest edge, scrape it against the roller (if it's black!). Vacuum the roller to get rid of the debris. If...
Condensation?? (After shipping?)
ALSO
silly (?) Question, have you shipped the machine full of paper? Is it damp?
Change the paper!
Define "after shipping"
Has the machine been refurbished by your company and shipped to a customer?
Has it been shipped to your company by someone else?
Have you seen it working before shipping?
Elvis has left the building!
The user seemed to say it works sometimes.
Duplicate ip?
Well done sir!!
I'm in the fortunate position of (in october last year) being able to balance cash etc against years left (?) And giving the finger to the career!
So, in refence to previous quotes
The less I...
I may know this one!
I recall something similar a while ago, there's a small control board behind the bcu related to the pressure lift. If u/s it will cause strange fuser faults including the ones...
So, this happened after you changed parts?
1st try sp2111 003 several times, if this works try 2111 001. If ok.... fixed!
Check there is no obstruction on the right hand door, if this isn't fully...
Be careful using cheat sheets!
They changed the parts on these machines as they progressed through 1065/ 75, into 2075 and then into the 6000 series. At one point the mylars changed, can't remember...
I do the same, using an old thermistor lead from AF8000 type. You're right, faster and easier than fuses! I also leave the top fuser cover off for speed.
We used to do similar on old Brother fax...
Chances of having an AF1075 reg unit...... slim?
I may be wrong, I remember one from a few years ago, drove us crazy! Pull out the fuser and duplex etc and check for paper or debris in ALL the sockets in the rear frame, use a torch and look very...
Not something stupid like a duplicate I p address?
Disconnect and ping the I.p.
Agree with tosko / slimslob, at 1.3m may well need reg mylars. Does the machine have an LCT? These knock out the mylars.Also look for signs of dev spill around the reg gears, could be leaking dev...
Note to self.... read previous answers!
Sorry guys
Hard contacts, not rfid, may be dirty?
This was 8 months ago!
Of course we updated the firmware
Mmmmm...... feedback..... Thanks for the update..... good fix!
Any other Peripherals installed?? (folder etc?)
Relay Sensor clean?
Dev leaking? (Kills feed stations AND Reg / Relay 1 way Bearings) Also Check for tight stepper motors on the feed stations.
Reg Unit Mylar Guides can wear as early as 450K...
Correct. But it's the toner END Sensor. if u/s will not asK for toner and will lose density over 200- 300 copies.
NEVER use forced toner! Use the "ID check during run" option which Can be used to...
JAM 001 is a "power on" jam so will show more when you open and close the door.
I would clean the exit sensors on the black lift plate (and the patches) They get Very dusty. I use my phone camera...
Been there, done that! spent the last 15 years (ever since we got laptops) saying 1) learn to Search on the laptop and on line, 2) Sort out your accounts with ALL Manufacturers AND save your...
If you get a call from a "Bob" re a Ricoh colour box, Just say "Sounds like a MUSIC fault" and pause.... You should hear the Brain ticking as they decide whether to ask "What's "MUSIC"? because they...