Hello, I have a problem with the machine Ricoh Aficio MP 6500. When I put paper in ADF, sometimes paper stuck. The machine gives me a message that it will be restarted, also if I open the feed cover...
Type: Posts; User: Vladika
Hello, I have a problem with the machine Ricoh Aficio MP 6500. When I put paper in ADF, sometimes paper stuck. The machine gives me a message that it will be restarted, also if I open the feed cover...
Yes it does, I found what was the problem. I have removed the finisher from the machine and found a piece of paper. That piece of paper was around the gears of fuser when the fuser was in the...
Hello, I have a problem, i turned the machine on, started to print and copy an a problem appeared. Paper stuck in fusing unit, on display I saw a jam code J15. I have cleaned sensors, checked all...
I'm sorry,
I only sad that I will try everything to try to fix that problem
Ihaaa, hvala. Pokušaću svašta pa šta bude
I did not try it, but I tried something else. From the other machine I took the unit which the motor was running and put it in this machine. Nothing happens, the motor will not start. Three days ago,...
Yes, it was :(
Thank you. I know that it does not work constantly :), because I tried it when I replaced it, but today when I tried it did not hear it pulsing. I do not know if it's possible to get a short circuit...
Hello, I changed the web motor, the machine works normally untill I have changed the new cleaning web, I have tested the motor in output check mode, the motor doesn't work. What can cause that...
Problem solved, ID sensor was dirty:)
Thank you
Hello, what can cause this problem? First stuck paper an then require to restart
36559
Hi, I have a problem with my copier, this morning I turned on the machine an the error code appears: 010-300. I turned the machine off thamn on and again the same problem.
The machine restarts again:(
I also tried to clear the memory with an eraser, so I combined, swap them, so take out one, then another. I tried various combinations and machine restarts again
Thanks, I just replaced a one used HDD because I don't have right now a new one. I did the SP 5832 001 to format HDD and SP 5853 to start download the stamp data with CONNECTED network cable. At the...
I did it and the machine works, but without network cable. Because when I disconnect the HDD and connect the network cable, the machine restarts about 5 minutes after powering on. So, maybe is...
Hello,
I have problem with machine Ricoh Aficio MP 6500, this morning appears SC 670. In service manual I saw that is the BCU board in question, I enered the service mode then swiched the...
Hello. I have the following problem: Master machine, which is held before me raised the temperature above the initial value, the toner will not burn the paper, when you scrape out a copy of the...
Ok, thank you very much :)
Can I solve the problem through the driver? To set Maximum Printable Area? Paper wrapped around the cleaning roller and so froze around it. Can this be a possible solution?
Thank you:D, yes I have from both sides of cleaning roller
Hello, two months ago, I put a new hot roller and a new pressure roller, but I have a problem. My machine is operating normally two to three days, then wrap the paper around the pressure roller...
Thank you :)
Hi, I have a problem with the cleaning web. The user manual writes me that the cleaning web is changed to 300K, but did not go three days she was winding the whole. This happened to me twice...