"Sure enough, the print head was flipped up. I am sure I checked this before but when I flipped the print head down and tested the copier I got good quality black prints." Bad design from OKi. ...
Type: Posts; User: vodo
"Sure enough, the print head was flipped up. I am sure I checked this before but when I flipped the print head down and tested the copier I got good quality black prints." Bad design from OKi. ...
Did you go in CenterWare and check on its printing references?
Have you ever seen one running without HDD? Yes, it has one. FORCE ALBOOT, dis-able data backup will erase all and reload its firmware any version that you wanted. But it only perform via USB.
Dis-assemble your machine again and re-assemble one by one. You had problem with Magenta Dev housing. Paid attention to it, you also may have to replace Magenta Dev due to its original problem:void...
Forget it. Replace its HDD and reload new firmware.
Your Black auger assembly needs to replace. The white tab at its end, broken or felt off which gave machine error.
Replace your hard drive. Reformatted won't work. You will have error back.
Your thermalpile dirty. Please clean it. Your Fuser still good, don't take it apart or replace anything, don't re format your hard drive or reload software.
Are you sure cable problem? If so, this is its part number: 962K74860, this cable connect I/F module to D finisher. There is a shorter one, PN 962K03170, this called communication cable. Check...
Your customer properly had wrong type fuser for machine. Check its part number, make sure it's correct. REmember the 7525,7535 is a same fuser and 7545,7556 is same one. Wrong voltage(120V or 220V)...
Its bushing needed to replace. Previously Xerox made that by plastic. The new one, it's brass. But, to ensure it will work properly, you will have to replace its clutch too. I do believe there is...
Check the blue color spring, left side of reverse gate. It may broke, which gave you problem. This problem is NOT your sensors.
Why not post your question?
Btw, forgot to tell youdo Force Altboot with Disable backup.
Replace, reload software then initilize NVM twice then reboot.
Check with Muratec...Fleet view. This could monitor customer usage, color/black & white, page count, alert low toner...
Good point. I think if I have a company, you would be my number one Manager :o. Mechanically incline, that what you're looking for. Test, diploma is a JOKE.
Needs to see its configuration print out. Without that who is going to know what you're missing.
Have you ever thought of replace the MCU-PF PWB? This doesn't cost much.
Properly one of your CRUM chip did not engage. Check your CRUM chip on its drum one by one.
Are you using Xerox toner and drum or third party?
Did you re-formatted HDD before you load back its old version?
Test its copy quality with know GOOD MACHINE's formatter board, PN Q3938-67977.
It is necessary, yes. To adjusts several Image Quality factors so that optimum copy and print quality can be consistently, by stabilizing the development potential and copy density.
It's not in Service Mode. Call Welcome Center and request a Admin password reset. They will ask machine serial number and page count, then they will give you a 12 digit feature key number. And you...