Search:

We changed both the transfer charge roller, and developer unit. Made no difference unfortunately. :(
Please share if any of you guys have more ideas concerning this issue. Does anyone think the...

Hello there!

Unfortunately, no! We suspected there was poor contact between the high voltage panel and the transfer roller-neutralizing brush. We cleaned all the contacts, joinings, but to no...

Hello Techs!

I'm having some trouble with one of our Taskalfa 300i units. The problem is that the prints come out with an ugly grey stripe/smudge on the back. The attachment will tell you more. If...

The only firmware upgrade I have is for the Controller. If any of you guys have the engine firmware upgrade kit, I'd like to ask you to share it.

Thank you!

Here you go a sample of the problem. These lines appear randomly over the prints, not on every copy their frequency of appearance is variable. Dirty scanner glass has been ruled out, these bad prints...

No, I keep getting prints with colored horizontal lines on them, and the service manual states at the 16.2.25 - 8th point: The resistance values between the neutralizing brush and the ground terminal...

Hello Techs,

I'd like to ask you where is the neutralizing brush located in the Bizhub C35 machine. The service manual refers to it, at the image quality problems section, but gives no information...

Greetings to all techs!

We bought four FS-1128 MFP units, all of them installed with fax cards. The problem is that each unit's software is FS-1028 MFP, and the fax is completely disabled. We have...

I've cleaned the main charger (the one sitting above the OPC drum) also cleaned the soft grey roller (ROLLER REGIST UP) and the brush (DC BRUSH ASSY), took apart the Dv unit cleaned the sidebearings,...

We useaftermarket toner, unfortunately the cost of the OEM is too high in our region. Please correct me if I'm wrong: the main charger by my knowledge is the roller located in the middle of the...

Hi to all techs!

We are experiencing a strange issue with some of our Kyocera and Trimph-Adler printers. These machines are equiped with DV-350 and DV-352 type developer units. Not too long ago...

One other thing that I've noticed this morning when I turned on the machine: It emitted a strange buzzing sound. The sound came from the side where the mfp board is mounted. The unit didn't start it...

The glass is clean and so are the laser windows under the imaging units. Can the mpf board be repaired or did you install a new one?

To whom it may concern,

I'd like to ask for some advice regarding a strange issue I'm having with a Bizhub C35 machine. 35252

Some of the copies I make come out as shown in the attachment...