make sure you are using genuine Xerox Toner.
And that the toner is dispensing correctly.
If not then you have block or faulty dispenser.
Worst case a faulty ROS.
Type: Posts; User: tech9
make sure you are using genuine Xerox Toner.
And that the toner is dispensing correctly.
If not then you have block or faulty dispenser.
Worst case a faulty ROS.
Hi The Altalink has serious issues with the colour. Very poor. Xerox have release a new version of software on website that is supposed to address these issues.
Replace the gearbox motor assembly.Well known problem on them.
misalignment of colours ?
Looks like it needs yellow and magenta dev or it could be a bad IBT assembly
Does the ejector move and white fingers go in and out when finisher initailises ?
Hello Techs
how to go to diagnostics for Samsung multixpress 8380dn or clx 8380dn how to remove password in starting the machine. and clx 6220fx
Thanks
Tech 9
Thanks have tried the special boot modes, that has not worked so will tried software.
the weird thing is, is there are no codes ? Fault log empty?
sorry i ment jams
hi there i have an m24 that jobs on 2nd page of print job with 3/4 of the print exiting into the centre tray.
Copies are fine. Have swapped HDD and r1,r2 roms and nvm rom plus ess pwb.Still no joy....
The TTL adapter fits on the serial cable and plugs in underneath the control panel. It is used to upgrade the UI software.
Rubbish material, the older 545/C45 etc had different material they were browny/gold rollers and they never ever melted.I think Xerox have come up with a differnt part number now i think they may...
That spells doom i wouldnt attempt it on that old dog.
57xx you can altboot via usb stick. You would although need a PWS if it lost its NVM settings.
The long and short of it if you really want to be the best of te best on Xerox kit the PWS is the...
Good luck firmware upgrades are bit touch and go, its been a long time since ive done one but yeah you need your parallel cable,serial cable null modem and TTL for UI.
If you just require network...
try an IOT nvm initalisation in diagnostics.
image overwrite is an optional feature you may or maynot have ?
It is located via the control panel in tools.
An Altboot will clean certain parts of the image on the Hardrive but anygood IT man...
Any got a code for one of these ?
Allagash 3535
Wildfire 5665
The 5837/5845/5855 was the Cruser family
The 5343/5252 was long bow/cross bow family
7556 Northwood
7500 Skyline
226 Camden
Just a few too much to mention
software module or sip pwb.It could also be a faulty fire cable or pwb.Disconnect the firewire pwb from the sip and see if it boots.
You may have to observe the leds and read voltages in the SIP...
the Lakes models ie (470 etc) all diagnostics and service was done via the Laptop !
Basic tools mode is key button and 1111
What altboot tool are you using ?
And PWS image ?
On the newer image you have to use altboot 6.1
and send the EBC file via the network cable.
No other way other than using a Laptop(PWS) with diagnostic tool.