Hello all, I have a Bizhub c452 with error code c3b05 which was reset and during warm up reverted to c3425 error. This was also reset but upon power ON, I noticed a chattering noise on the IHPU...
Type: Posts; User: r4roty
Hello all, I have a Bizhub c452 with error code c3b05 which was reset and during warm up reverted to c3425 error. This was also reset but upon power ON, I noticed a chattering noise on the IHPU...
Hi forum members,
I have this issue of developer being sucked out of the MG roller usually accumulating at about 10cm width looking at the Dev tank from the front door side thereby producing dirty...
thanks problem solved
Hi all
How do I reset c3925 error after removing the fuser unit of this machine to enable me remove the transfer belt but in the process a wire pulled out from the center temperature sensor plug...
Hello All
While trying to bring out the transfer belt of this copier, I removed the fuser unit however after re installing the removed items and switched on power the copier failed to warm up but...
Please help offer solution(s)
No display problem was solved by replacing blown out fuses 2nos on 24v2dc and 24v3 dc on the DC power supply unit .
When the power was cycled , the machine failed to...
The actuator carrier of the charger cleaner for K imaging unit which is a plastic worm gear shaft that slides to and fro the front and rear cleaner position sensors could be broken. If confirmed...
Hello all ,
This is my first post on this forum Thank you (newbie ).
I need an advice on how to completely resolve this problem .
The service manual says E-501 is an interlock switch failure...