Reimbursement model covers 24mpg, not my 2003 Tahoe. Been trying to sell it and get something more gas savvy but so far no luck. Done over seven thousand miles in six or seven weeks.
Type: Posts; User: Ratchet2501
Reimbursement model covers 24mpg, not my 2003 Tahoe. Been trying to sell it and get something more gas savvy but so far no luck. Done over seven thousand miles in six or seven weeks.
True that. I used to be oilfield for five years. This work is much safer though not as well paying, for now. My only real complaint at the moment is using my vehicle for everything. But, there are...
Been a while but I'm back. Now a Xerox IT analyst instead of a sharp technician. I am finding that in some ways I dig Xerox a LOT more than sharp but in a few ways I'm still a fish out of water when...
Yes it is the Altalink. The screen shot is on a thread somewhere else reflecting the area where my machine gets weird. The second check on disable booklet layout is what just resets everything back...
I have an issue with the stated machine not printing booklets properly.
https://xerox.i.lithium.com/t5/image/serverpage/image-id/6850i67D1F25EFCAFC2AA/image-size/original?v=v2&px=-1
This is the...
Customer brought the machine in and after fiddling with the LSU and getting nowhere I tried re-replacing the developer cartridge and even though the other had a good 25-2, it fixed the problem. I am...
Welcome
Sharp Mx-m363n Firmware request. Has a HDD but no Security.
I used the cleaning wand and checked it out with my light, seemed alright but the results speak for themselves. Next time I go there, I'm pulling the lsu (looks like a pain on this one) and checking...
Welcome
Seems like it is. Can that cause such an isolated defect in printing just on the one color?
39272
Copy of the 64-5 B/W shows left side of sheet pretty much blank, readable but not very dark.
Update: Sim 48 had some weird settings 50, 63, 50, 76 and 50. Assuming that 50 is the default/middle ground I reset everything to 50 across the board. Looked better, until I reran the 50-28...
I can't even recall how many times in the last year I've been doing this I've had half the machine's guts on the floor and I hear "I can't print can I?".
Welcome
I could easily look past them not mentioning the mx-c312 but this talks about the ends going through not one side. I will scope it out when I'm digging around in it. Going to try re-replacing the...
Fuser, transfer belt, drum assembly and developer are all new. Replaced the transfer belt today since I didn't see anything immediately wrong with it, still light on the left side. Going to hunt down...
I need to get better about snagging copies of crap like this, get creative that way nothing is publicized about the customer and such. Recently I struggled with a job interview because of my "habit"...
Welcome to the forums
o7 from naples utah U.S., how's the weather over there?
I have a machine that has started to trim the width of a copy by maybe a tenth of a inch. I have run through the gamut of 50-28 calibration and while that made it better, it's still taking some of...
May your neighbors respect you,
Trouble neglect you,
The angels protect you,
And heaven accept you when the time comes.
Nope, nothing would get done. *facedesk*
Stupid sensors anyhow
The fuser was replaced recently but forgive my lack of copier experience but that doesn't seem like it would affect a single color without all four going to crap. Secondary transfer system is a...