Hi
Just been asked by a customer if they could print out the department codes, but I could not remember how.
Could anyone help me?
Thanks
Type: Posts; User: OJ the Bodge
Hi
Just been asked by a customer if they could print out the department codes, but I could not remember how.
Could anyone help me?
Thanks
Hi, I dont see a lot of these machines but the problem I have is it jams with code jam40. Jamming at exit.
This is intermittant, but also it looks like the reg is well out, but that can vary from...
It could be the power supply is pulsing only on D/sided jobs. I have had a similar problem with intermitant jams in various places
You could just short out pins 2 - 4 to make the loop, that will get you going until the connecter gets to you.
No company car as I'm a walking tech, just a oyster card that allows travel on London transport, the closet I get to driving is seating at the front of the DLR (driverless trains).
Do drive my own...
I do Canon,Kyocera, Sharp, Samsung and HP
Work for a big dealership about 400 staff, 100 techs
Started in 1988, there were no middle aged or old engineers then.
I would start with the basics, whats been done before, make sure the coronas are wired with Tunsten not gold wire, then move onto the dev unit see if the toner is genuine canon, pirate stuff can...
Canon NP150
Been called many things, not all to my face from
copier mechanic,
Toner jobby person
mr fixit
mr fuc*it
copier man
xerox man
troubleshooter
troublemaker
hero,
In the distance past Canon brought out a Duel componet I think it was the 1812.
What a pile of crap that was, had a TD sheet that had to be done up with 7mm socket,in the right order, no normal...
Hi
I started out with a hard case but with the introduction of the laptop I tried a few different types of cases, but I have a side bag with a shoulder strap, other guys have laptop back packs....
Check the lamp heater as it may have a small crack in the wiring, which may only open up when scanner is moving.
Make sure the heater is put on in the correct location as it may block a sensor.
If...
Hi, depending on the age of the drum you may need to change that, but 1st turn the drum around to see if the blur moves to the other end.
You wont get the white spots out if they are pitted into...