Does anyone have an idea why this MPC7500 will not print when Ring Binder RB5000 is connected to the machine?
Type: Posts; User: Oluwadare
Does anyone have an idea why this MPC7500 will not print when Ring Binder RB5000 is connected to the machine?
Ok but what exactly is responsible for the machine speed apart from the Controller. Can anyone help?
[QUOTE=Is there any other thing that makes the difference?
But the IPU and BCU part number for for all these machines are same
What exactly is the difference between these machines because the IPU and the BBC are thesame yet D1205740 Controller board is still showing SC995-03
meaning incorrect Controller board. Any useful...
So what could it be. Pls I need your help seriously
All that was done but nothing good.
Thanks a lot Slimslob. But how do I get this firmware. I'll greatly appreciate if any one can help me with these firmwares as a set.
That has been done but no success.
They have their separate power cord and all were properly connected and turned on.
They have all worked together perfectly from installation until recently that it stopped. I am also looking the direction of firmware, but except some guys will help me. I don't have access to...
Hi guys. I have one MPC7500 that has Z-Folding unit, Book Binding Unit, Punching Unit and a finisher. The machine gets ready but it will not print even meter counter. But as I disconnected all the...
[QUOTE=Cipher;495418]Sometimes the data on the NVRAM can get corrupted, but a NVRAM chip actually going bad is a pretty rare fault generally.
I would start with the controller, and go from there....
Thanks Cipher. I will therefore place order for the Controller Board. But is there need to replace the NVRAM also?
I have tried removing the ram yet the error remained. I am actually looking at two things. 1 BCU + EPROM 2 Controller Board + RAM. But I'm afraid to place order since I'm not very sure which should...
There was a surge in customer's premises that affected most of their equipments including the Ricoh MPC5502.
I have checked the PSU which seems to be fine. I have powered it on with HDD...
SC494 can also result from toner bottle not fitting properly into the toner hopper.
Pls send the solution for SC554 on SPC830dn to my email as i am also having the same challenge at the moment. sunjayng@yahoo.com
I'll appreciate your quick response to this.
Thanks
Yes, the sponge roller that is behind the charge roller in the pcu.
Anyone know if the cleaning roller under the drum unit for MPC4500 can be found seperately?
must the controller be replaced? Is it not possible that someone know how to reset the
NAND Flash Memory on the controller board which is the cause of the problem?
I have SPC820DN that displays SC582. I have replace the IOB yet the problem is not solved. Has any body any idea on how to solve this problem? Your urgent contribution will be highly appreciated. ...
who knows how i can get the controller board for MP3350 and how much.
kindly explain to me more about fitting the ram to a laptop 'cos i have a similar problem in which the ram went bad.
your clear explanation will be appreciated.
That message does not only print at start-up but from time to tme even when it is not connected to a system.
I still need your assistance.
Best Regards
Oluwadare