Now isn't this true considering the field as a whole? Companies small and large do this I feel.
Type: Posts; User: ShonRipz
Now isn't this true considering the field as a whole? Companies small and large do this I feel.
Was it the machines you didn't like, or your employers?
Was it the machines you didn't like, or your employers?
Looking for opinions or comments on working on Xerox mfps or working for Xerox direct. I've recently gotten a job offer from Xerox.
Ricoh instructors recommended i clean the mag roller with folded up paper. i personally would use a scotch brite and lightly scuff until the black was all gone. just be aware that everytime you do...
Problem with development. a bad charge would cause Dark lines, not white voids. check if your transfer roller has a line or groove in it. Next i would check amount of developer in unit, could be low.
I may be wrong, but I do believe there is a tsb currently for the 03 series for a clicking sound due to the fuser drive gears. There are updated gears that reduce adrasion. If that is not the cause...
Happened to me last Friday on a mpc 4502 and again this morning on a mpc 2003. Followed procedure for fusing belt replacement and when powering on always has a sc552 code regardless of what I do....
I would check again. I don't think the 557 had airprint.
These are great machines. They have their faults but they usually last over pm and they're easy to work on for me. I enjoy them.
If the flat glass copies fine, you have an alignment or mirror issue with your RADF. If the flat glass does not, you have a dirty mirror or optic. Start by checking your mirrors and ARDF alignment.
Good idea! I would Point to the PCDU after checking for outdated firmware. Something is causing a TD sensor error so check your VREF values and monitor them. Could be possible damage to the unit. Or...
Smh* yea you're right I jumped the gun. The exterior of them looks the same
. sorry I didnt realize :/
This is what I've gathered so far. I wonder if removing the board and manually rebending the pins would work?
Having the same issue with yellow on a mp c305. Says toner not detected. I'm lead to believe replacing D1175162 BRB corrects thisnissue? How are these toner hoppers different from the old toner...
Hey friend! 99% sure you will need to replace black toner pump. Always happens on this model machine and it's mostly always black for some reason. Remove the toner and drum underneath it (black or...
Noisy fuser units!
Error is for Knurled roller shift solenoid abnormality: An abnormality occurs in the knurled roller shift solenoid. [MJ-1042] this problem is occurring on an estudio 4508a
This problem started 1...
I've cleaned fuser exit sensor and I've been unable to duplicate this issue. Tested all trays no problem but customer tells me the paper stops out of the fuser. Is there a jam report for these...
I know the mp2553 has Adf free run sp-6009 .Anyone know why the 2554 doesn't?
Try adf adjustment sp mode 7002 I believe for skew correction sensor. I had the same problem where scans would jam at the skew sensor but copy was fine. The skew correction had to be reduced to...
I would reformat the hdd and reload firmware. We order these hdds from hytec. Their website has a component parts search.
Go to user tools -admin - and print a color calibration chart and upload the result into this thread. Seeing that sheet could really help troubleshoot this issue.
Reset fuser sc code and activate fuser high temp start. If the high temp is failing you could have a bad fuse installed. The only time I've ever had it fail was when I forgot to install the fuse.
Most of the time I find skewing is due to the paper tray fences not being tight to the paper or the gear that drives the paper fences are broken. Remove the tray and take the metal plate out. 1...