Hi
for incomplete phase install go to 131 chain 3 and change 2 row install phase and dc install phase from 0 to 4.then restart .
For fuser incompatible set the correct region in dc131 chain 3...
Type: Posts; User: shaahin
Hi
for incomplete phase install go to 131 chain 3 and change 2 row install phase and dc install phase from 0 to 4.then restart .
For fuser incompatible set the correct region in dc131 chain 3...
Hi
The control of fuser is in the low voltage unit.
if fuser is good so change the low voltage unit.
I can't find 391-973 fault code
391-928 is magenta crum fault
391-929 is cyan crum fault
change M&C crum chip or replace M&C drum cartridge.
Hi
what is the fault code?
Hi my friend
you must change the amount of dc 131 chain 3 both install phase and dc install phase from zero to 4.
regards ali
Hi
Check the fuser and main low voltage.
Hi all
When i use reduction or enlargement i have very movement in copy and print .
how can i fix it.
thanks all
Hi all
how can i change 252 with efi fiery to build in controller.
Hi
u1 belong to main motor.
also check the low voltage.
Hi
when you change the hdd , you must install software again with flash memory.
make a folder AltBoot on flash root then put 58xx software in this folder,
power off machine put the flash memory in...
Hi
what is the fault code?
Hi
did you check the software ram (NVMRAM), HDD, and HDD power cable & data cable.
if good ,check the touch screen ribbon cable.
Hi
The Developer is low. add developer to fix this problem.
The weight of developer and housing is about 4350 g.
not yet . used beafore coppier only.
and i can't connect with laptop.
thanks for reply
but in tools ,the machine hasn't any network option to change.
and isn't any notification about network in configuration sheet.
Hi all
I have a problem with xerox 5225.
connectivity and network setup not appear in xerox 5225 tools.
so i can't set IP address for print or scan.
how can i fix it.
An abnormality was detected in drum coupling contact/retract
check the following
. the transfer unit for mechanical loading or damage
. the drum coupling contact/retract for loading and drag...
I did it
Thanks all.
hello
anyone knows how to make the docucolor 260 fuser reset.
I fix it by change hdd.
thanks for your reply.
Hi
I have a problem with xerox 7545
after power on ,the machine is offline.in tools i change it to online.
and at the next power on the machine is offline again.
how can i fix it to online.
Check the following:
A paper transportation failure due to a foreign substance/burr on the paper path
Each Duplex Roll and Pinch Roll for contamination, wear, and revolution failure
...
Prepare a USB Flash Drive
Ensure that the USB device to be used has sufficient free space to contain the files to be downloaded.
Create a new folder in the USB Flash Drive and name it DWLD.
Copy...
Hi all
I have problem with Xerox wc 5655 with OCT .
when i use DADH in 1 side 3 copy comes out
and 4th not completely out .and in platen 1 & 2 side is OK.
Please help :(
Hi
clear the value of NVM [744-248] to "0",
Initial Actions
•Turn the power OFF and remove the Fuser Assembly. clean termistors or see if paper is wound around the Heat Roll.
•Check whether the...