Search:

I also am having this problem on a DF-7100 internal finisher attached to a 2553Ci,in addition when stapling 2 sheets double staple the two pages are not aligned by maybe 4mm,but the staples are...

I have a C7110X that intermittently will not fuse ,the machine will cycle saying its adjusting fuser temperature,then after say 3 minutes of this will start the print job and everything that comes...

I didn't hear any unusual noises ,but I will listen closer,also the waste toner bottle was brand new so perhaps they let it back up before they replaced it.

Thanks I will check that out,I did clean those contacts but I didn't look closely at them.

You could set up the machine to require a code to print,default the code into the four clients print driver defaults and wait for the complaint that someone can't print,that will likely be your...

I've got a Kyocera 6535cidn leaving streaks where the id sensors are located on the 1st copy or print out in the morning,previous tech has replaced all the drums,DV's and transfer belt,sure looks...

I work on both the ricoh production ProC7110 and the full line Kyocera's,if the placement is right the Ricoh Pro's do a good job other than the booklet finisher I'm told,The problem is design wise...

You seem to have a color registration problem and a yellow drum unit problem.

The separator pad was replaced,the problem is double feeding not kicking codes,you reduce pressure between the pad and feed tire to increase separation not stretch it to increase pressure decreasing...

The separator pad was replaced,still misfed,reduced spring pressure slightly to increase separation,still double fed,will try the sep pad from the 1128,thanks

We recently have run into a slew of 306ci,406ci,456ci machines with standard dp units having double feeding problems,examination of the friction pads show pretty severe wear at 2000 scans and 30000...