I would replace the T/S blocks and if the copy is still light I would run Sim 20. We've done that several times on the 4530/5530 with excellent results. I would run Sim 20 first if I didn't have the...
Type: Posts; User: Hutcheson
I would replace the T/S blocks and if the copy is still light I would run Sim 20. We've done that several times on the 4530/5530 with excellent results. I would run Sim 20 first if I didn't have the...
I would also pull the processor from the cad controller and clean off the heat sink compound and use fresh compound on it.
C 2000
Image formation motor problem
• LOCK ALM signal remains high for 1
s, 1 s after the image formation motor
has turned on.
Poor contact in
(Hey,
I need help for KM-C2525E.
When I make a copy with the DF, one side is dark, as if there was a leak
light. There is no problem with printing and copying by platen. I searched the solution...
C3300 Optical system (AGC) problem
After AGC, correct input is not obtained
at CCD.
Poor contact in the
connector terminals.
Check the connection of connector YC5 on
the ISM PWB and the...
It sounds like you need to run Sim 906 to reset partial operation control. You get into sim by entering 1087087.
I'm sure you've probably thought of this but it sure sounds like a print job that got sent to the 1128 that was intended for a Sharp or some other model printer. Maybe a conflicting IP?
We are in need of an exit switch actuator for a Konica Minolta 7450. I don't have a part number or list but it is located on the top or the fuser that flips up to access for jam removal. Any help...
Just to follow up. The fuser was in excellent shape. The thermistat had already been moved and I think they said they have the problem when they run envelopes in large numbers (200+). It hasn't...
Thanks for the info everyone. I was able to reset it and I'll go back later and reposition the washers. Thanks for that heads up wazza.
You mentioned that you recalibrated. Did you mean to say you did the registration adjustment? If not that is what I would try first.
Can anyone give me some info on this code. We're a Kyocera dealer and one of our customers is asking for our help with this machine. Thanks in advance for your replies. Steve
Updating the firmware will usually resolve that problem.
Run SIM U004 and see if that helps.
The Mita Image unit has a different jumper wire that is located underneath the top cover. If I remember right you have to remove the toner cover and the top cover from the image unit to get to it....