Yes just do copy gradation adjustment
Type: Posts; User: nassor
Yes just do copy gradation adjustment
Sensor problem try to clean or replace
Try to print from Microsoft word documents, if it will be OK uninstall your adobe program than install new one
Good luck
Do Initialize + stabilization
And gradation
Clean a sensor
Good luck
It use cf card
Yes I have
Sound like laser unit confusion.check laser unit cable/belt
Sound like laser unit confusion.
Try to change RAM
Try to disconnect and connect again the laser belt
This caused by developer charge and some time more toner
Try to reduce your Developer.
Check cyan Developer
Can you try skew adjustment? If u tried it, disconnect the laser unit cables (belts) and reconnect
Reset the code and try to print if toner is high remove the cartridge toner, and keep empty Cartredge with active chip.
Relaxing, no big issues, this because your developer has no toner. So just take a few amount of toner and put in your developer unit, and wait machine to run, then try printing, if not yet put in...
check: Developer Unit, or Fusing unit.
Attaching ur images please
Its different but u can use there parts, like opc drum, cleaning blade and developer powder.
OK I understood, so can u try to update firmware
may not big issue just configure your network again. call ... admin-network setting-tcp/ip setting- ipv4 setting - manual input. than set ip address, subnet mask and default gateway.
just change your pick up roller
Try to use different
USB flash drive.
U should no harry for it, just leave the unit and wait 1,2 or ...hr for machine to auto ujdust all environment condition.