I'ved reached the M1 drive motor and changed it. It was located behind the main board in the left side.
The error was C5102. It took me about 2-3 hours for changing it. Operation succeded despide...
Type: Posts; User: Xtended
I'ved reached the M1 drive motor and changed it. It was located behind the main board in the left side.
The error was C5102. It took me about 2-3 hours for changing it. Operation succeded despide...
Hello Everyone.
I have a Konica Minolta C353 and i have to replace the Drive Motor (like in the picture from the atachement).
Cand anyone tell me where is the exact location? Is it in the back of...
EVRIKA !!!
5. Network Setting, 8. System Connection and 9. Security Settings reappeared in Administrator Settings.
Thanks Synthotol for the solution and all the others.
So i made the...
I will try this solution today. Thanks.
I've tried several combinations of IP's in TCP/IP, but i remember that i canot leave the gateway 0.0.0.0. It gives me an error.
Anyway i will try and i will...
Thank you guys for your answers and for your time.
I guess I'm at the end of the journey with this problem :)
The only solution would be to buy a Recovery Tool and a CF Card compatible and the...
No, i can't enter ADMIN/NETWORK/TCP/IP. This tab is still not available.
Right now i'm under a network of a neighbour (a wireless network,conected to it with a TP-Link USB adapter), and the...
I've print a test page from : Menu/Utility/User settings/printer settings/print reports/configuration page.
TCP/IP: Enable
IP Address: 169.254.142.25
Subnet mask: 255.255.0.0
Default Gateway:...
Emujo, i've unplugged the usb, restart the printer.
Same outputul when arp -a.
So, If my ip address is 192.168.1.106, i have to asign the ip 192.168.1.107 with the mac address of the printer wich...
arp -a output:
The first one is a connection on a wireless router and the second one is the ethernet conected to the printer.
Interface: 192.168.1.106 --- 0xc
Internet Address Physical...
Ok, what setting do I have to make so that my Konica pull an address? Shoul it be static with a crossover cable, shoul it be in a router network? How should i configure my PC to make Konica Minolta...
I do not have a DHCP connection( router network), because my location doesn't permit to have a broadband internet connection (i have an usb modem to conect to the internet). I use a crossover cable...
I've made this operation. No luck. Network tab still missing and the error "Waiting for ARP request" appeared.
Should i make this operation with the crossover cable pluged in the printer and also in the PC?
Thanks Synthohol for the quick reply.
As far as I understand from your post to achieve the Firmware for the Bizhub C353 i have to login to MyKonicaMinolta.com
But how do I register to...
Hello everyone !
In have a big problem with my Konica Minolta Bizhub C353 (excuse my english).
I have used a cross-over cable to connect to my printer and everything works fine.
In have...