Search:

Hi everyone, I'm asking you for confirmation, now I'll explain what happened to me:
I went to replace the hhd of this mp9002 for the second time, which the first time gave sc672-00, ok fine
then...

usually when the machine eats up the toner, you have to replace the pcdu of that colour, it happened to me a few years ago on mpc2003 with yellow, (I had also opened a discussion here) I recommend...

you can notate bad hhd when you load the address book in wim, that load very slow, anyway a bit time ago , sc672 by bad hdd its happen also to TULIO here.

it happens every now and then, last Friday mp9002 sc672 replaced hdd.
a month ago mpc2503 sc672 replaced hdd, and others that I don't remember, a good way to understand it is the speed of access to...

replace the hdd for first thing

it's the first thing I did, and I found solutions like "turn it off and on" or "unplug and plug in the formatter", but since the customer is very far away (it takes almost a morning) I would be...

Hi everyone, I usually stay in the ricoh/lanier/gestetner section.
we have this customer reporting this problem on that unit
(61.00.03) print head error (on display)


I'll start by saying that...

I advise you to remove auto-select by selecting tray 1, and to store the condition in delfault mode in the "program/store" button, the one with the memory symbol (the diamond), and set drawer 1 in...

BINGO!

finding the right diameter, you could try cutting a piece of those insulating foam rubber tubes, which are used to prevent outdoor water pipes from freezing....but that's fine.


62268

[SOLVED] it was just that stupid gathering roller that got soggy, replaced with AF03-2094, thanks for your cooperation


622346223562236

I think too, it's a problem that also affects internal finishers, which use that replacement, which is also quite expensive (32 euros!)

....I don't understand why they insist on using that...

Hi everyone, tomorrow I have to go and look at this problem, the machine was recently installed, and I checked both the machine and the finisher carefully before delivering them.
the customer...

TOH...get this!

I told you above what you have to do, the connector, and the termoswitch's, check the both plastic lever if lock well, and are no broken

bad fuser contact, if you want to try a cheap thing to do...
clean well the contacts of the fuser connector and those on the machine with a cotton swab and alcohol, you can also use a scrap of light...

if both cause problems, it could be a strong accumulation of dust, the ideal would be to dismantle both pick up stations from the machine, and give it a good blow of air....just to start off

try to check that in the paper cassette setting, where the weight is indicated, the "apply to duplex" item is selected

I don't remember how now
the cards of that model are engineered, but if it prints well from LAN, and not from USB, it could be the image processing channel of the USB part, I would try changing the...

5-801-008

unfortunately in Italy, they are only in Italian, however I am sure you will translate it easily

most likely it is the coupling between bearings and pressure roller, if so, I recommend using copper grease (the one you put behind car brake pads, to ensure they don't whistle when you brake ). I...

get this...lol

It happens not too rarely that they break down, it happened to me too at home, then following the "rumors" on YouTube, I bought myself a nice Fritzbox 7530, and I'm super happy

well...I don't understand what machine it is? however, if it's physically possible, try to swap the drum cylinder and the charge unit from yellow to black, to see what happens.
and try to clean and...