the pm cycle is 400k on the cs3050. depending on how long ago they had pm time may have shortened the life of drum and dev. we never ever use non oem toner in our machines. if I recall the toner...
Type: Posts; User: itchyfinger@att.net
the pm cycle is 400k on the cs3050. depending on how long ago they had pm time may have shortened the life of drum and dev. we never ever use non oem toner in our machines. if I recall the toner...
i drive my own car. 2016 ford flex. my company gives each tech a company credit card that covers gas, maintenance, and tires. no complaints here
you can also pull the cover off next to the black toner to the right and move the selonid by hand
fixed it person says they did not have print server. come to find out someone send a wirless print to copier, but status shows nothing in the que. after we found and deleted it then some prints...
hello all, have a 4052 that when one of the colors run out it shuts down the unit. we have it set to print blk/white if color runs out. has current firmware. tried both restart and 906 via KFS. ...
I had a unit do this same thing. replaced the feed tires in the cassette and have not had the problem since then. check 251 and if they have over 70 k replace them think it was a timing issue...
also try the current driver
any codes? maybe reseat magenta laser j connectors?
have CS6002 that makes a grumbling noise when ever it comes out of sleep mode of fired up in morning. unit has current firmware, new style bridge unit in the pf unit and fuser replaced as well as...
It can be hard to tell if the fuser or the exit assm is the problem. We have replaced both in units only to have the noise return. Finally I just started to oil every shaft, bushing and idler gear...
hello all, we the only dealer or have other dealers been having squeaking noises from the 02 series? we have put several exit assm and fusers in the units and they only last a month or 2, then...
make sure you using updated drivers and current firmware. Go through and make calibration, tone curve adj and ect. And see what effect it dose for you
oh ya jam codes and c codes would help maybe a 906 reboot
did you pull it apart and look at the drums? seeing a lot of the units with cleaning blades not cleaning properly
look at the 307ci Copystar so far we have had great luck
Hello, Still have not found a solution to the HASH MARKS in the K drum only. unit is at current firmware, have replace drum and developer together. Bulletin pertaining to sim 100 is set to 1. ...
agreed dirty charge roller clean all 4 of them while your in there and vacuum out the cavity. if you see blisters in the roller while cleaning it, replace it with the new style.
firmware is always important. go in to sims and reset 163 1nd 167 I believe. this will reset the counter for the fuser and should reset the 6000 codes. is it doesn't make sure you have good...
I would think impression roller or pressure. you say if switch drums it follows because its the master..I would try making a new master on each machine and see if it is the same on both machines. ...
its been a while since I worked on both A B Dick and Rizo digital dups. Make sure your impression roller is clean. any buil;d up or groves can cause this as well as the ink knife being plugged in...
check your waste toner coming out of the transfer belt and to the bottle.
look on page 266 of the service manual, item 24 its in the eject assy.
went out there today and reflashed the firmware. checked all the settings in the machine for forwarding and they are turned off. had customers it guy check their outgoing email setting and...
Hi guys, have customer that has one person in the address book that when he scans to email my boss also gets a copy of that email. have looked at the send/forward setting and it is turned off as...
it has been my opinion to use the full version instead of the turbo. you rewrite the whole version and not have any problems this way