i have checked both clutches on other machine work fine. also the conveyance door from another machine checked. i have checked the the M1 motor at back of machine. nothing works. i have also changed...
Type: Posts; User: Gulbadin
i have checked both clutches on other machine work fine. also the conveyance door from another machine checked. i have checked the the M1 motor at back of machine. nothing works. i have also changed...
bizhub 601 shows J 1705 jame code . and there is no paper in vertical transport door. it only copy from tray one and bypass tray now.i check another photocopier vertical transport door but same jam...
Can I use bizhub 600 board in bizhub 601. I use on in 601 but now paper exit/ reverse gate not working.
when i go into the user box only use document and save document option are present. HDD is installed into the copier. but when i check it in service mode the HDD shows unset. please guide me how to...
not exactly this but this kind of
my bizhub 600 copier is not booting. it show wait icon.please can any one give me its firmware .
zahidpak93@yahoo.com
i was using bizhub 600 as a printer but after turning off dhcp the network setting does not show any more so i cant connect to it from pc.
i have replaced 3 times the tone tank gear. the gears. the gears does not rotate smothly.what is the cause of it.
Thanks you have fixed my problem. The small spring was lost.
Please upload the picture if you have it
Xerox wc 5765 make noise when copying from bypass tray and also it will pick multiple papers at once.
please find me the solution for jame code j-3202.
i have done that but no luck
bizhub 600 web solenoid is not working.
xerox 5765 show replace xerographic module . the fault code is 03-320.xerographic mudule is 220 % remaining and life is 0 day.
I have xerox 5765 in duplex print the front print is upward from the back side
Xerox 5765 always jamming between the drum and heater and give code 10-102 and 08-100
xerox 5765 paper jam problem in the fuser .code is 10-102 and 08-100.please help me solve the problem
after replacing bypass tray the copier is power on with noise from bypass tray.and also when i print it make noise and give jam.please tell me what i have done wrong inreplacing.
yes the paper is fed from bypass tray
38903
when i copy on A6 paper the result is crooked skew on bizhub 600.on A4 paper the copy is fine
I have Xerox 5765 and it get too much energy so it would not work on generetor because it can't get such load.is there any method so it can work on low power