Search:

send me a pm with ur email
Will send you c8000 part list

firmware is only available to km tech/providers
if you need firmware you can donate to this forum

i can also provide you any km firmware you need

hello guys
its me bothering again, i have problem in c8000 from customer, cant get around it
toner is leaking under 2nd transfer section as in photo and like the much it is ends going even to adu...

13E2: Engine flash ROM write error

Sent u pm

Hi folks asking for your help
I am getting:
J-3103:
During operation: The registration sensors /Fr
(PS1) and /Rr (PS2) do not turn ON within a
specified period of time after the registration...

Forgive my noobness i checked machine on rear, and saw in A1RFN10902 Fixing Wiring /2, one plastic drawer connector was broken, so it would not be completely fixed from movement, and vibration would...

err, looks like i was wrong, it happened this time but without printing, it was on calibrating ("please wait, making adjustments") and suddenly it happens c-3106 again, so wasnt caused by jam, most...

hello guys
looking for some help, has someone happened to get this error while printing and a jam occurs?
this is what is happening ----

jam occurs (any jam) --> goes to jam screen indications...

C-6801
Classification
Operation section: Initial communication unreached error
Cause
After the sub power switch (SW2) turns ON, the communication between the overall control board (OACB) and the...

C-D0E8 Hard disk/Y (HDD/Y) disconnected.
Otherwise, either broken or during initialization.

Thank u for answering my friend
Luckily customer got charge assy.. i replaced and problem gone

hi guys
while printing on customer 1250p, text and everything looks okay
but pages with images like this, get this banding (whis is constant among all the pages)

i just replaced drum and ran...

SENT U A PM

this from 1250
very similar procedure
attached on image

sent u a mail

check PM

you cleared both the consumables counter (special parts counter) for each consumable
and the maintenance counter?

yeah i meant by that Setting Tonner as in my post bro

[COLOR=#3E3E3E]

Would it harm if i use C8000 setting tonner? A1RFPP0000


THANKS TO YOU BOTH FOR YOUR ANSWERS

thanks bro, must look very well then, by the 2 times i have seen check this model with cellphone led lamp cant seem to find any
the image enters like this to fuser so the problem is in earlier...

thanks again once for replying
nope, it does on every one and single colour print and with bypass tray too, as seen is 2 pictures next (test no53)
even in only black happens too

isnt fuser...

Thanks a lot for answering
Yesterday i tried cleant all the charge grids
Cleaned also dust proof glasses and even run the machine without them
I blower brush around where the dust proof glass goes...

Hi folks
Today i swap c1070s intermediate t. Belt cleaning unit with a new one.. but forgot to remove red screws from it.later realized it.. itb has no scratchs or whatsoanything im getting this...

Yah did you release the 2 blue screws on the cleaning unit?
To the middle position(released)?

Printers c8000 started printing like this today. It should be solid but instead it has all those lines.
I tried multiple color reg,toner refresh, gamma auto adj, reset factory presets, looked in the...

@AjitN
enviroment humidity is okay, around 50~ish

@D_L_P
thanks gonna check the contacts for HV
developer fairly new only 22k copies ago, using only oem supplies

thank you both