Finally found a fix. Export EEPROM&SD data from a good machine with SIM 56-2 to the bad copier. Works great!
Type: Posts; User: JLVisser
Finally found a fix. Export EEPROM&SD data from a good machine with SIM 56-2 to the bad copier. Works great!
You're welcome!
There is a solenoid that opens the shutters. That solenoid is probably bad. You can test it with Sim 6-1, LSUSS.
Best way to check this is to interrupt a print job, pull the primary transfer and look at the image on the belt, then you'll know for sure.
It pulls developer out cause the DV filters get's clogged up. The developer unit will build up pressure when moving so if your filter is clogged it will cause toner dusting through the doctor gap in...
You say there's no toner on the drums? Sounds to me like your shutter solenoid is not opening. How did you test to see if the shutters open all the way? Remove the black shutter temporarily and see...
Hi Ivan,
You have probably checked this, but just to make sure:
1. You cannot use 8.8.8.8 as a DNS (for scan to folder) because it will not resolve local host names. If you are using local host...
Check if the white plastic flags are broken on your paper guides. The trays must lift up before it can detect paper. On that guide there is also a black plastic flag. That flag sometimes goes under...
Do the latest firmware update. Newer versions of Windows does not support SMB1 due to all the ransomware issues last year. The latest firmware will allow the copier to use SMB2 and 3.
It's attached to the inside frame of the main drive unit.
So you have a MX-MF11 installed on the LC13?
If you still have the problem and tested all the countermeasures above, change your NIC speed from 1000 to 100.
Also check the gear that drives your primary transfer belt. That screw comes loose and the gear eventually breaks. There should be ZERO play when you manually turn the gear.
The 6240 will always have a lead and trail void area. It is not possible to print full bleed on trail or edge. If you could, you would have constant jams. It can however print full bleed from rear to...
Does anyone have a fix for this? We have the same problem. When doing a 46-74 the test pattern print out fine. The adjusted pattern is very light and the copier doesn't even read the printer test...