is this machine in an enviroment where it could possibly suffer from condensation , years ago we use to have machine suffer from this and give black/dark copies/scans, good luck, we would appreciate...
Type: Posts; User: kyoceran
is this machine in an enviroment where it could possibly suffer from condensation , years ago we use to have machine suffer from this and give black/dark copies/scans, good luck, we would appreciate...
check to see if the screen shows the outline of an SC code eg 202 or similar, a lot of the time you need to replace the laser polygon mirror motor befor repairing/replacing the board concerned, and...
many thanks, it seems Ricoh hide this very well, have a great day.
Good evening, is it possible one of you fine folks would have thenumber of the ricoh bullettin for the modified transfer roller housing assembly, many thanks in advance.
the fuser warms up and it keeps turning over, but I am not aware of pagescope
i'm now struggling to get a resolution to this, have replace ops panel cable, and the flat interface cable between the mfsb and the print controller pc, I would suspect many of you are well versed in...
many thanks, no codes, fitted second unit and still the fault continued, kined up the positioning pins etc, still no joy, many thanks for your help though
Good evening super heroes, last week i attended a call with an error requiring the k laser unit to be replaced, today i returned with the kit, after instlling the units, the prints either produced...
may need a different type of transfer roller guide, there was a tech bul for this, good luck.
many thanks for your replies, the copies are good when original is placed on the glass, and I have used various original type modes to alleviate the problem, possibly looking at pcb replacement.
as I stated in my original posting this avenue and the cis have already been replaced and cleaned, the crux of the matter is the over exposure of DF fed originals, but many thanks for your advice
I was wondering if any of you fine folk had come up against this issue I have on an Develop ineo +25 where it now copies good , but when you send an original through the DF the copy comes out...
found customer was trying to print an internet generated print, cleared the item from the print queue machine worked ok , good luck
Is there any vendor of the film sleeve only for the new type machines, on the HP printers its possible to just replace this film sleeve rather than the whole assy, any suggestions on preventative...
good box on the whole, but on two separate machine we have experienced the k IU going feint on the op and is only fixed by re inserting the K IU, any ideas for a long term fix, Develop unsure !
Good evening, I have recently been suffering from this machine overexposing when copying only. prints are great, have tried all sorts to no avail, this accompanied by a continual request for the...
I merely asked whether these people contribute to this site, character assassinations are not the sort of behaviour expected from those of us who genuinely use this site for Imaging industry...
whilst we can see this site needs finance, does it charge a fee for those who seek to profit financially from this site eg selling manuals ?
Good afternoon folks, we have an spc240 with the code SC690, the manual has very limited info, Ricoh support can only suggest replacing the engine board. I wonder if any of you in travels have come...
apologies for the delay folks , the info you require is Ricoh Technical Bulletin for model AP-C2 6th October 2011 RD029075 for 220/240v machines.
I hope this moves your fault finding forward, as a...
totally removed fuser again, found wire to left hand side wall connect below fuser to be hanging, thanks to everybody for their contributions.
ricoh have a RTB out for this, it involves replacing IH, IH inverter pcb, fitting a gaurd over the drum phase control sensor and the 8A fuse on the primary.
How many overpaid sales reps does it take to sell a copier ?
Answer ? none, the customer will tell them the prices
will try again monday thanks
After fitting new fuser, the machine now displays the messge 'initializing' have check all work carried out, made sure all connectors are correctly fitted, now hitting the proverbial 'wall', any...