Search:

thanks for the info. I will give it a shot. how is this going to effect user Pin numbers? they have quite a few of them entered.

Working on IR ADV C5030, and set up the email feature for the client. About every 15 minutes the email will not go through for about 2 min. Then back to normal. Using SMTP. Any suggestions? I...

I am looking at xerox DC242 with error code 077-304 tray5 top cover opened. THis happen after copier was moved from office to basement. I checked all the interlockes. Even if i disconect try 5 (...

I am working on image runner 5055 and the problem is with size of email attachement. they scan large docs and it creates big attachements 10mb+. so it will split job into two separate emails. ...

I am working on M5035 that has this issue that seems to be worldwide. WHEN SCANING, IT WILL CHANGE ORIENTATION OF ORIGINAL DOCUMENT AND SO IT WILL RESULT IN CUT OFF IMAGE. page after that might be...

I replaced developer material, performed toner sensor calibration ( hopefully correctly), but it still does the " adjusting copy quality" thing before it makes copies. I dont have any fancy tools to...

I have seen jams like that on 9050 at around 500K copies. The problem was registration assy gear wears out. If you wait too long it also might wear main drive gear where it connects with...

Have a Xerox 3030 thats giving LL.30 cutter fault. the sensor passes in diagnostics, motor does too. first feww copies come through fine but soon it will start cutting too early - lets say about...

No I have not done it Yet, probably in a week or so. One guy told me you only need to tun the adjustment for voltage for developer. There are couple points on hvps that reads developer voltage. I...

Is there easy way to do it?

I looked at two different machines. 3030 and 8025. Both have simular issues. After replacing toner ( customer states) it started to print background and also went through toner quite fast. 8025...

Hi I looked at one 6204 that was making noise and was producing very light print. I noticed that the noise has to do with light print. I eventually got it to go away. All I did, in order for me to...

is there older and newer model of those finishers?
Becuase the one I was looking at had gray plates and in order to get them out I had to loosen the lift motor assy so I can slide a shaft that was...

would this also apply to ARm280U models?

I have a ricoh 1045 that i have been working on for a while now. among other issues one that i can't seem to resolve is that there is about 3" wide toner build up on the drum. it happens after making...