Hi, I got asked to change a cartridge chip on an epson T7200, with refillable cartridges, I have no prior experience with these types of printers, and I never printed on this particular machine...
Type: Posts; User: Jozsef Hollo
Hi, I got asked to change a cartridge chip on an epson T7200, with refillable cartridges, I have no prior experience with these types of printers, and I never printed on this particular machine...
Thank you, someone told me to post it here :)) there is no Epson forum yet, so I did not know where to post.
Hi, I got asked to change a cartridge chip on an epson T7200, with refillable cartridges, I have no prior experience with these types of printers, and I never printed on this particular machine...
Thank you very much!! I was searching for epson, but then I will post on HP.
Hi, sorry for my reply here, I actually have a technical question, not an answer, about the T7200 epson, but I don't know how to post a new thread with this topic.
I hope not, on the intenet I read that i could use some, damn it!
Hi, in service mode I found some timing loop adjustments for registration section, as the manual says to avoid skew or jaming of papaer, do you think these settings could have anything to do with...
Copy and print as well, I cleaned the roller with "print roller cleaner and restorerer". sensors with alkohol. Uhm, how do I buff the shaft? I don't know what it means, sorry.
Thank you for your post, the manual calls it registration clutch I will take your advice and try to find out if I can make adjustments like this.
Damn, I can't find in manual or the web such...
Hi, we have a Minolta Bizhub Pro 920, but the print doesn't always align to the center of page, it was worse before I cleaned registration sensor and rollers, but it still can have sometimes an...
Yes, it does it on other type of paper and tray and bypass as well. I'm not a tech, I get stuff fixed by reading online but for this problem I couldn't find any information, i don't know about...
Hi, it is the feed direction
I replied to the thread as well with this same picture, the top one is alignd to center, the other two are not, the difference varies and it is always the lead edge, these where printed face down40062
Hi, here is an example of the problem, the top one is perfectly centered, there are two closer to the left edge, it was printed face down it is the leading edge.
Hi, we have a bizhub 920 and the print doesn't always line up to center, it can have a displacement of up to 2cm twoards the travel direction of the paper when printing.
It gives no error codes, so...