Check sim 26-1 to see if some one has turned on the job seperator option this will give you that message if it is on and no seperator tray is installed.
Type: Posts; User: mike2565
Check sim 26-1 to see if some one has turned on the job seperator option this will give you that message if it is on and no seperator tray is installed.
If you put them on before the blade is on then one side or the other will lift the the blade and cause it to flip. If you look at it after the blade is installed there is plenty of room to get it on...
Make sure the red felt seals on the sides are put on after the blade is put in. I had the same problem and since I put seals in this way the problem went away. I hope this helps.
there are no fax limits in department ID when you go into it. I've checked all over and Canon and the jamex coin box company are saying this model will not fax on coin box. When you turn on For coin...
where do i find the limits?
I have an image runner c3525 that we hooked up a coin box on and it was able to fax at first but now after about a week or two it has stopped and is giving me this message. 41266 Any help would...
So those cartridges for the cannon finisher the d1 are the same thanks Guitar9199:D
Hey folks i am looking for the staple cartridge holder part # for the ar-sc2 staples. any help would be much appreciated.
we also are having the same issue doesn't make sense sense they ride against plastic gears how does metal wear out before plastic. We changed the whole drive unit and motors and so far so good.
We had one doing this it ended up being the sensor right below the secondary transfer unit. sensor 2tpd.
thanks everyone i've found that the filter in the back of machine gets plugged at about 700,000 to 800,000 copies and isn't drawing all the heat out.
is anyone having problems with the sharps mx-m365n,mx-m465n and the mx-m565n where the drum keeps flipping the blade and going into c1-10?