that sounds about right. had a few of these go, usually on the same machine over a period of time
Type: Posts; User: jarwil
that sounds about right. had a few of these go, usually on the same machine over a period of time
Is the board on the LHS of machine looking from the back.
Is board repalcement, go through with a multi meter and should find a open circuit. Can't remember if it is top or bottom of the board
Check for blown fuses on Printer Control Board. Common problem
Thanks for that guys. Worked a treat.
Another solution supplied by Copytechnet.
Thanks again
Is it possible to disable or delete the language button from the control panel? The one down the bottom right hand corner.
Thanks
make sure you get Device Status in the print driver so the driver knows that Dept ID's are on
Check the waste toner box is correctly installed and the door is shut
What are your jam codes?
The Magnetic Card Reader is supplied from Bear Solutions but provide they no support for it.
Konica have advised our dealer that Bear devices are usually connected to the vendor port in the back...
We have Pagescope setup at the main office, but this is for the Library for Public printing. Only printing to one C280. 2 different systems.
Thanks for that. Will get in touch with Konica Dealer
We are trying to connect a Magnetic Card Reader to a C280. When the USB is connected a icon displays down bottom of C280 control panel showing USB and a red cross through it.
Card reader is a...
Different series machines and different doc feeders so would say no
You will need a screwdriver. Front cover doesn't just pull down. Two screws holds the cover on
You don't have pcl kit for machine. Try downloading UFR driver for machine and see how that goes.
Check the two green levers on the fuser aren't pushed all the way down in the envelope position. Have seen this cause double image and dirty copies. Levers should be flicked up for normal printing
Was a technician but now moved to IT help desk. Look after a fleet of copiers now but make the call for techs to visit. Makes quite a change
I would doubt it. Should be different part numbers.
Need to be replaced as a full set, not individually.
Konica have a ftp utility that is easy to setup and can eliminate SMB errors. It is called FTPutility and downloadable from tech site.
your computer is 192.168.1.102 and your printer is 192.168.0.108.
If you change the printer to 192.168.1.108 then it will be in the same range and most likely be able to ping and print. Or any...
Have a 40P on our network that is having printing issues.
Sometimes print jobs will print straight away, sometimes jobs will process for 10 minutes and then print and sometimes jobs abort and...
Machine we had the same issue with had done less than 100k. Only seen it happen once so far. But more and more machines getting out there. Handy to keep a spare clutch just in case.
could be irty drum sensor. A service on the machine should fix
I'm with Wal on this one.
Had similar and ended up being the dev clutch. Suprised if it isn't the clutch.
Have a IR1022if with Scan to SMB error #806.
Know that it is either incorrect username or password or incorrect destination.
Is scanning to a Windows 7 box. Folder is shared.
Have even...