Background all over the page i can see. Is this your problem?
Type: Posts; User: Polo-022
Background all over the page i can see. Is this your problem?
D196-6002 Transfer Unit Intermediate Assy. (Only Assy, no belt separately)
120K. Prints.
Replace Cyan PCDU. Particularly, the PCU eats toner when it fails.
No bulletins at all!
Image is reduced when scanning to email only
I found this...
Check Laser Beam Path for obstacles.
I have a scanning mode problem with this machine.
Scanning from platen glass, the image is shifted too much and a black border
appears on both sides(Short Edge-Long Edge). When i print the scanned...
Reset the corresponding counter through diagnostics.
It must be the Yellow Developer Unit. The Toner Density Sensor has failed.
Replace as required.
Fuser Unit Replacement stopped paper jams. It was a premature failure of it
and i did not take the risk to re-oil the pad, or to replace it.
Thanks again for your support!!
My next step will be transfer assy replacement, to check mostly the wiring of fuser entrance sensor and the next fuser replacement, or parts of it. I have to say that there are no broken gears, or...
Well, i did the same thought, but i didn't replace it yet, but i will, tomorrow!
It curls just like an excessive damp paper, no dog ears, it never enters into the fuser area. Yesterday i replaced side door interlock switch, today i have reports that it is jamming again.
Firmware is up to date and the feed rollers are at a very good condition.
No missfeed jams.
Machine jams randomly, paper does not entry into the fuser.
It curls just under the fuser module and it happens from all trays,
same thing, even if it is A4 LEF, A5, A4SEF.
Counter is : 155Κ Βκ &...
D023-9660 Developer material/Cyan.
D029-3035 Development unit/Cyan.
Original parts MP C2800.
Humidity condensation on the drum which has been exposed to humidity overnight.
It usually happens where there is not a well ventillated room.
I use to polish the drum and properly dust it with...
Only when copying, not at scanning or printing mode and it happens randomly,
but very often. I replaced HDD first of all and it was working for several months,
but now it appears again! Ofcourse i...
Paper end switch actuator has been deformed, or
the metal base where switch is mounted,
giving faulty messages to the controller.
In addition to this, replace friction pad.
Laser Unit synchronization maybe! I have seen that sometimes back in the days of MP C2500.
It recovered itself somehow...
Electrical noise, power cord, grounding, network.
Yes Codex, i have the same problem with this Ricoh model. Not very often, but it happens.
PM at 50K. prints, seems to be normal.
It is the tandem tray rail. Screws that secure it at three points have been loosen.
Remove the lower left cover and pull all the way out tandem tray to repair it.
Very common on Martini series and...
Sp c362dnw printer - sc-332-01Take a look here Mikado...
Yes, it doesn't work.