Search:

Type: Posts; User: Hansoon

Page 1 of 20 1 2 3 4

Search: Search took 0.07 seconds.

  1. ECOSYS P2040dn showing Call Service 2000:0006256

    Got from a wholesaler an almost brand new ECOSYS P2040dn. Machine is booting up normal but when picking up paper making a shaving noise and showing Call Service 2000:0006256.
    I have the Tech Manual...
  2. Replies
    6
    Views
    1,175

    Re: Opinion on Oneway Bearings

    I clean them blowing out with air then pulling the corner of a light rag through it and then soak the rag with Isopropanol, turning the one-way back and forth. If they are over 300K I replace them. I...
  3. Replies
    9
    Views
    3,829

    Re: ECOSYS P2040dn fuser

    Thanks guys.
    How does this printer know when the toner cartridge is empty? Chips, sensors?

    Hans
  4. Replies
    2
    Views
    226

    Canon iPF710, ink cartridges.

    Customer has loads of ink cartridges for the Canon iPF710. They are unused and in the original packing. Stored and protected from light and heat very well, but are however in storage for over 3...
  5. Replies
    3
    Views
    1,286

    Re: Lexmark/IBM Wheelwriter 3000 power supply

    Would be interesting to know why they got blown. In the old days, in general most PU's were suffering from dry or blown caps. I repaired a zillion monitors and TV's because of that.

    Hans
  6. Replies
    9
    Views
    3,829

    ECOSYS P2040dn fuser

    Not being a KyoGuy I have two questions about the fuser of the ECOSYS P2040dn.

    1) Is it worth the trouble to replace the film only with after market films?
    2) Any instructions please how to...
  7. Replies
    9
    Views
    1,130

    Re: BH-C-284e, scanname when scan>e-mail

    YEP!

    That's the solution.
    Thanks CopyTechTrouble and thanks to all the other guys for their input.

    Hans
  8. Replies
    9
    Views
    1,130

    Re: BH-C-284e, scanname when scan>e-mail

    Synth, the procedure you describe I cannot find in the manual nor with Pagescope. In the Pagescope machine interface there is an empty list allowing 10 subject entries, but there is no button to set...
  9. Replies
    9
    Views
    1,130

    Re: BH-C-284e, scanname when scan>e-mail

    Thanks TSB. That is not working either.

    Somewhere in the machine once has been entered "CAN-C-284e" resulting in that the machine sends scans to e-mail addresses with a subject line: Message from...
  10. Replies
    9
    Views
    1,130

    Re: BH-C-284e, scanname when scan>e-mail

    Thanks Synth, but I'm looking where to change the SUBJECT, not the senders e-mail address

    Hans
  11. Replies
    9
    Views
    1,130

    BH-C-284e, scanname when scan>e-mail

    Mails made with the scan>e-mail function are having the subject: "Message from CAN-C-284e" I looked around but cannot find the place where to alter this. Any help please?

    Hans
  12. Re: Paper draw 3 on C253 missing 'open' button on front and also not opening

    LOL, NO!

    It is a childish way from my side to ridicule all those silly announces like "Made With My iPhone xyz" or "Made with my Android ABC" etc.

    I'm using W10/11 in my computers with iCore...
  13. Re: Paper draw 3 on C253 missing 'open' button on front and also not opening

    Look at the lower back of this 3rd tray unit. There is a tiny hole where you can put a very long pin (knitting needle...) to unlock the tray mechanically. It needs some poking to hit the unlock...
  14. Replies
    1
    Views
    399

    BH-C-284e C-4802

    BH-C-284e coming from a wholesaler with C-4802.

    Machine boots up normal showing all the usual shark fins and comes to a complete ready for a few seconds than C-4802 pops up.

    What to do....
  15. Replies
    16
    Views
    1,711

    Re: W11, using the build in Disk Mirroring

    Thanks, but the rather steep learning curve is going slightly over my head at the moment for this particular single customer only.

    In my own office, I use an automatic backup with Acronis to NAS...
  16. Replies
    16
    Views
    1,711

    Re: W11, using the build in Disk Mirroring

    This is going into directions not intended by me. Thank you all for your input, guys.

    I decided to have those two 2TB disk mirroring and as an offsite backup I will use the, since years proven,...
  17. Replies
    16
    Views
    1,711

    W11, using the build in Disk Mirroring

    W11, using the build in Disk Mirroring a good idea, or is it better to use a NAS with RAID?

    I have on this computer a 500gig SSD for the operating system and two identical 2TB Hard drives for all...
  18. Replies
    3
    Views
    563

    BH-4000p, strange effect

    Customer has a BH-4000p which a few times a day prints gibberish using W11/64. See attached sample. When I saw this, my first thought was “driver”. Strangely, it does this only when printing...
  19. Thread: MX521

    by Hansoon
    Replies
    2
    Views
    507

    Re: MX521

    Great site, thanks!

    Hans
  20. Thread: MX521

    by Hansoon
    Replies
    2
    Views
    507

    MX521

    Anyone having for me please the service manual and parts manual for the Lexmark MX521?

    Hans
  21. Re: Win 11 Print Driver icons taking up to 15 minute to appear.

    Had exactly the effect SalesServiceGuy described by a recent install, and it drove me nuts in the beginning. I used as always the Settings from the Start Menu.......

    Hans
  22. Thread: C3351

    by Hansoon
    Replies
    13
    Views
    1,069

    Re: C3351

    I recall that a long time ago there was a very similar problem with the ancient Di-183 machines. A very fine, sharp line coming up from time to time. Minolta told us those days that it's a bug in the...
  23. Re: BH-C-284e with FK-511 Fax Kit, did I say I !HATE! fax?? ***SOLVED***

    Problem solved by using the settings "VoIP optimized settings from the L. Teske Liste" as given by Gift.

    Thanks for all your help guys.

    Hans
  24. Replies
    5
    Views
    505

    Re: C-454e, "original left on glass"...

    Cleaning the underside of the platen glass helped me often with this problem.
    Even when looking “clean” there seems to be something which can be polished off.

    Hans
  25. Re: BH-C-284e with FK-511 Fax Kit, did I say I !HATE! fax??

    No, the wide KM cables are landing always in the bin here. I use handmade two wire cables with modular plugs RJ10 4P2C to avoid crap like I have now. :)

    Hans
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4