The name of the bulletin is RD194171.
Date 8-may-2018
Type: Posts; User: RG1964
The name of the bulletin is RD194171.
Date 8-may-2018
Is the screen not working or the touch part?
The touch part is the USB connector at the back of the screen.
Get's disconnected if they rotate the screen much.
First: make a testprint for each color. (to see of they are all scratched)
Check the metalplate below the ITB belt and check the seal/guide on the ITB belt. (or temporarily remove the guide)
Could it be a bad contact at the seperation (ptr)?
The contact screw loose.
Had a simular problem at a Pro C 7100.
Nope.
First difference is the drive coupling.
And there will plenty more.
PSU 6 is near the purgetray, you have to slide it out from the back.
Read the manual, all psu's are connected.
Have fun:mad:
Took me a few hours to make the right conclusion.
Check the SC history. If there's a load of SC's you might have a PSU failure.
Are all the blowers working at start up.
In my case the machine had a blown fuse on the NYRB board (behind the...
"One is for black and yellow and the other is for cyan and magenta."
Y is on the left and K is on the right. Large laserunit.
Make an image on the itb and check if you can see the line. Looks...
Machine doesn't recognizes the option.;);)33325
I'm talking about this, not the tpner collection system.29561
Check the recycle system at the back of the machine. It might not turn fast enough due to heavy load or be broken. At the drive dite there's a sensor. (could be dirty)
You will need a special sp...
You can use the glue for model airplanekits, it's in a tube (thick) but there is also a liquid one with a brush to apply the glue.
Good luck
Can't you replace the mylar with a "homemade" one? In the worst case i would order the exitbelt, undo the bold/nut (exitpawl) and screw it on to the old belt, It's a lot of work to replace the entyre...
Check the server configuration. I think you have a problem with the APPE Adobe print engine. It's on the last tab of the configuration page. You better not select the second option on this page. Or...
I forgot, you have to use a special reset methode. You can find it in the manual.
Might be a broken coil in the recycle system. Get the complete system out of the machine en check for damage. When you're lucky it's just a toner block. On the early models the coil slipped at the...
Would be welcome if one of you're manuals had a solution....
Don't forget: all the black stuff is written by the laser unit!
Did you clean the registrationsensor and there's no paperdust on the blackspot it's looking on?
Did you adjust the belt speed sp 6xxx. (can't remember the exact sp)
Is it possible the ADF is on...
When the power went down, it might have been updating de control panel.
The only solution is to replace this panel because you can't replace the nvram that's blocked.
The manual will tell you that...
Excellent machine in the sales folder. Quality geat.....
In the past we had some trouble with the center thermistor. (martini c1)
Damp or moist gave us some real shit, after repacing thermistor no more problems.
Got the same problem. We just replace the roller. The chemicals in the paper destroy the registrationroller.
Try another brand of ncr paper. It worked, but was too expensive.:(
Does you're customer use carbon less paper?
Are there any lines in the 'white margin'? Black lines means the laser is writing. In my opinion it can be the laserunit or a bad hdd.
When i am copying copier freezes and looks like is working...