Thanks,
I'm not totally sure. I had it in my head there was a head sim that printed a coverage report.
Although I could just be imagining it.
Edit. 22-25 is what I was looking for. I'm not...
Type: Posts; User: sharphead
Thanks,
I'm not totally sure. I had it in my head there was a head sim that printed a coverage report.
Although I could just be imagining it.
Edit. 22-25 is what I was looking for. I'm not...
Can anyone tell me which simulation shows the coverage.
Thanks everyone, the error reporting one time switch is the most important for me. Getting to set the % remaining would have been handy but not essential
28 bit 3 to 1 - error reporting 1 time
...
Thanks for all the replies. A soft switch was the kind of thing I was hoping for. 28 bit 3 to 1 - error reporting 1 time sounds like the answer.
Another quick question on bit 32 the default is 10%...
Hi,
I'm looking for some advice on what you all use for alerts and meter readings
We are using a print collection engine, that recommends installation on the server. We've found that even on a...
I'm going to "service and connect to the internet" next week.
I've only experience on Sharp.
It's for a stationery customer who have taken over another office and I've been asked to get it...
Would be worth thinking along printing/ network lines.
Is the computer upto date? Is PoE possibly a cause?
Think I read on here recently about PoE causing issues on a MX2614
System settings- Network settings- Wireless settings- Access point mode
Curious,
Sounds like it might be a timeout issue. Ie the df sends scan as soon as last page is finished. On the platen it asks if you want to add another page.
I would try extending the smtp...
Thanks for the responses, a few things for me to consider.
Thanks just curious
Did you ever get any further with this one?
We have seen a number of this generation sucking the developer out. On all colours, on high and low volume machines.
Has anyone seen similar/ have a theory?
Are your developer bias, transfer and main charge voltages good? I wonder could the yellow transfer be getting a bad signal
Is it plugged into a different electrical socket now?
Are the...
A better translation than block would be unit.
I also wasn't sure if you had replaced it, or opened and cleaned it.
These units need alot of electrical current. Would the move have it using a...
Sometimes we hurry too much...
Sorry I don't know where I read about the clutch.
Easy rider is pointing out its the paper feed motor, not the lift motor
The error code mentions a clutch as a possibility has it been replaced?
Did you ever get this one sorted?
I seem to be having a similar one and can't figure it out.
Thanks, that's all I could see myself
I've swapped the LSU and am certain it's a faulty thermistor in the laser unit.
Problem is, it seems you can't just buy the thermistor. The whole laser is the only part avaliable.
Does anyone...
Hopefully it is what blackcat says.
Failing that the mother pwb used to go on these quite often.
Any boards in the UK?
Part number CPLTM9048DSAA
Thanks
Thanks Dave
Thanks Billy,
Our wee vans won't take a full height MFP anyway so needing to borrow the big van.
Haven't dropped any yet. So there is the scud put on.