I have 2 3050's that have been well maintained, cleaned etc... Both have about 400K Prints on them. The copies/prints have marks on them that look like a Bicycle ran over the page. Example: ( <<<<<<<...
Type: Posts; User: Executechs1315
I have 2 3050's that have been well maintained, cleaned etc... Both have about 400K Prints on them. The copies/prints have marks on them that look like a Bicycle ran over the page. Example: ( <<<<<<<...
Did anyone ever see what looks like bicycle tire marks on the copy/print. After cleaning everything it seems ok. Hard to tell where it's coming from. Machine has over 400k but kept machine clean and...
Left door not latch corectly could definetly cause that. I've seen a Tech mess with all the characteristics of the main board, causing crooked copies, bad print quality, margins were off and center...
All the black copies I ever had with the 3050, 4050 and 5050's was always due to the Main Charge Corona Unit. I usually remove the motor that cleans the corona unit, because they fail a lot, and...
I did the reset (Held small hole on side, wait for small dot on display panel, pressed 3 and pressed trouble reset). and bingo there was light. My book had a mis-print in it, I would have been there...
Hi all Have a Di 200 with error code c 0500 (Low Fuser heat).
I checked the Fuser Lamp, Thermal Fuse, Thermal Swith and Thermister. All Tests Good. After resetting (The little Hole on the top right...
Hi I have a Minolta Di-200 with c0500 code (low fuser temp.) I checked the Heat lamp, Thermal Switch and Thermal Fuses on Fuser Assembly. I reset the code and goes back to c0500. Was just wondering...
Blackcat... that's exactly what has been going on with them. They load the tray on one side and use the other for storage. The paper size detector or back-stop is usally not vertical and the paper is...
Did not try the 906 reset, The upper imput to tray #1 does not have a good snap like the lower imput. Don't think it;s on the tray because it works in the lower tray imput.
Rear black connector...
Tray #1 won't work / I reversed the lift motors and the white switch in the rear from Tray # 2 to Tray # 1 still won't work. 11" x 81/2 Tray is ok...works in tray 2. Anyone had this problem please...
Did you clean the Grid with alcohol...