Hi Perth,
Well, I replaced another sensor, PC14, it ran one sheet through, and then after that, it jams every time.
If it was a bad fuser unit, it wouldn't feed even one sheet would it?
I...
Type: Posts; User: adastra100
Hi Perth,
Well, I replaced another sensor, PC14, it ran one sheet through, and then after that, it jams every time.
If it was a bad fuser unit, it wouldn't feed even one sheet would it?
I...
Well, I replaced the exit sensor, and that wasn't it. So much for paying for expedited shipping...
The paper still jams right when it's entering the fuser unit. This is getting ridiculous!
Does...
Hi,
There is print on the paper, and I recently replaced the transfer roller.
I talked to one person who said it's probably the exit sensor, PC10.
It's the sensor that detects when the paper...
Hi Bhangdu,
Could you tell me where that is?
Thanks
I am having the same problem on my CF 3102.
The paper jams right when it gets to the fuser unit.
I replaced the fuser unit with another one, and it still has the same problem.
When you say...
It worked!!!!
I cleaned around the area, put the imaging unit back in, and it fixed it.
Thanks so much!!
I am stuck with 3 jobs to do-and a stalled Minolta.
I replaced the black imaging unit, and now I get Error Code 13D6.
Does anyone know what this is?
I can't seem to find a list of error codes...
I have almost the same problem.
It seems like the background was covered with tiny spots of cyan evenly all over the sheet. I ran the stabilizer, and did a gradation adjust, and that is better.
...
I am trying to print a full bleed on the second side of an 11 x 17 sheet on my Minolta CF 3102. The transfer roller is a little old, but I cleaned it carefully. I think it might be an old fuser unit....
Thank you Selig67!!
Fuser clear
To clear the fuser error code, perform the following after correcting the cause:
1. With power ON, open the front door and locate the small, rectangular...
Thanks, I will try that.
We have A Gestetner 3355 that has been jamming every 25 sheets. It almost seems like the fuser rollers aren't turning.. It always jams at E1-E4.
Does anyone have any ideas?
Thanks in advance.