Turn on the risograph.
Try to use hot air at this place, for example from a hair dryer.
if after heating the risograph turns on, then it is likely that STR G6153 should be replaced.
Type: Posts; User: risografist
Turn on the risograph.
Try to use hot air at this place, for example from a hair dryer.
if after heating the risograph turns on, then it is likely that STR G6153 should be replaced.
http://risografist.3dn.ru/drivers/RP_CD2_0_Win2k_XP.7z
http://risografist.3dn.ru/drivers/RP_CD2_0_Win98.7z
0.8 mm
If you send a one-sided sheet, is it also jammed?
Make a photo of the place of the jam with a jammed sheet.
search: Riso RP Color Drum
Riso RP Color Drum Risofederal Blue Ink with Case Duplicator Risograph | eBay
Riso RP Color Drum RED Ink with Case Duplicator Risograph | eBay
In the power supply there is a standby board, usualy it is necessary to change the STR G6153 chip on it
This problem only for EZ series.
It's happend when a lot of papar jammed. imho, it is not hardware problem.
Try to change firmware.
pull out the drum of your riso. rotate it and find place "on the upper right hand corner of the stock #10 envelope". stick on a piece of adhesive tape to the master tape in that place.
look at the picture
C23 Master Cut Malfunction
• If the Master positioning sensor is still detecting the master (light
reflected back) when the Drum is at position-A after the cutting
operation and the Master...
Users manual: http://risografist.3dn.ru/manuals/CR_User_Guide_en.pdf
RISO CS2000 - Color Separation Software for RISO Digital Duplicators.
It is included at no charge with every RZ990, MZ790, and EZ590 unit sale.
I lost my copy. May be somebody can upload it on the...
Put video of working riso (with sound) on youtube.com .
May be somebody recognized this sound.
CS-2000 doesn’t support PostScript printers like CI300 or linotronic.
CS-2000 used only with GDI RISO interfaces with RisoRinc language.
Clamp Error (1)
* In 4 seconds from turning ON of the Clamp solenoid in clamp
retrial, the Clamp safety switch is held still pressed down.
* In 4 seconds from turning OFF of the Clamp solenoid,...
You can use standart driver (from windows installation), wich support HP PCL 5 or Adobe PostScript Level 1 ( HP LaserJet III).
You can use only
B4 Drum/250 x 353 mm image area
or
A4 Drum/198 x 286 mm image area.
1. switch off your riso.
2. press at the same time left and right positioning button.
3. switch on your riso, when the battons (2) is pressed.