The PINOUTS are not in the wiring Diagram. all it shows is the Connector. I need to connect a third party card reader to J1026. The card reader has an *Enable (Normally Open) of relay *Enable...
Type: Posts; User: mikeadel
The PINOUTS are not in the wiring Diagram. all it shows is the Connector. I need to connect a third party card reader to J1026. The card reader has an *Enable (Normally Open) of relay *Enable...
I assume you are talking about the IRC3200, These drums will go till they fail. No End of life Fuse, or message. Ive seen them go over 300% before quality issues. The black drum tends to dump toner...
Thanks, But I already know where J1026 is, What I need is the PINOUTS, ie what each pin on J1026, Enable/disable pin, copy pulse, etc.
I need to know the Pinouts for J1026 on main controller 1. This is the where the interface kit A1 would plug into if you were installing a third party device, such as a card reader. Its a 9 pin...
Also if it has a Fiery attached, this will definetly need calibrated after copier grad adjust. You will need the gray scale strip that comes with the Fiery print controllers
Thanks for the info Andrew, its much appreciated. If ya ever need anything for Canons or toshibas, let me know.
How do you init the dev? i am puttin in fresh dev, also rebulding drum unit with Cherger roller and cleaning roller . I do not know how to get into service mode. also will i need to reset the drum...
How do you init the dev? i am puttin in fresh dev, also rebulding drum unit with Cherger roller and cleaning roller . I do not know how to get into service mode. also will i need to reset the drum...
How do you init the dev? i am puttin in fresh dev, also rebulding drum unit with Cherger roller and cleaning roller . I do not know how to get into service mode. also will i need to reset the drum...
Thank You, I will give it a try. It is a Fiery X3 and not the Konica IP 601. I think I have the mini centronix cable somewhere.
I have the System Software CD for the Fiery X3 on a 7075. Its been years since i've had to work on these and I dont remeber how yo update the system software. The hard drive crashed on the Fiery....
"Fiery.1" is the default Fiery Password, as far as I know this is true for all newer Fierys Hope this helps