thanks for all help. Cannot install firmware. NIC will not initialize. Is it bricked?
Type: Posts; User: Jude
thanks for all help. Cannot install firmware. NIC will not initialize. Is it bricked?
I do not see the "scanner power board" replacement procedure. Is it the same as the ISC board? The Set Target looks easy enough. NOT! It would take a rocket science to do all the formulas. I kid...
Thanks Cat! Do you have the recommended procedure for replacing the scanner PCB?
Thanks Geo. Did you mean MM425? Set Target value? The procedures in the book?
364373643836439364403644136442When I print internal prints or from PC the colors are good. But when I copy from the feeder the prints are bad. I have attached a sample. Please advise:
I think this is it? WorkCentre 6400 File Download
anyone have the .dlm file firmware? How to get it? I have manuals or firmware for swap.
We replaced the scanner belt on this and started up after but screen says please wait for over 60 minutes. We rebooted and still no joy. Cannot access the menus or service mode. Is it bricked? Double...
Yes we are getting the SC543, 542 codes. I am not saying yours is the same p[roblem as mine but when I see weird trouble codes that wont reset after parts replaced then I am suspect board problems or...
We are having similar trouble with a MPC 3300. The moachine is at construction site with no dedicated power. The problem stars with fuser then we open door and boot but cannot acccess the SP modes....
Customer installed a black non oem cartridge and a week later gets add black toner message. Prints are very light. Cartridge is full by weight. Sent a another OEM black cartridge and installed. Still...
[no network activity bumped having same on MPC3300. I tried different cable, all suggestions on ths page.
anothertech, would you care to elaborate since I do not have access to the goose guides.?
seems to be the cyan is problem. The blue banding you see is weird. So is the offset. Just looks like registration is way offf.
Yes that would help to give some detail. Weather here has been nice last few months. No snow just record warm temps here in the Northeast. I grew up in the Midwest and wish for warmer temps there for...
I want a fax system V for Kyocera TA3500i. Anyone?
Gears only align one way, right? We did it according to the book!
Here ya go! Film at 11:
http://youtu.be/ESm-mhjEC_Q
Changed the fuser and gears. Still very noisy like the rubbing sound. Anyone have any experience with this?
Call me Ishmael. Some years ago -- never mind how long precisely -- having little or no money in my purse, and nothing particular to interest me on shore, I thought I would sail about a little and...
does anyone have or get access to SNF Basic versions and accessibility?
Yes, if I only had a setup disk... Bought these machines off lease. Thanks for the help guys! Does anyone else have anything?
Not a whole lot of help .I only use this as last resort AFTER I have read the manual! The settings do not store in the computer. Any one else can help me?
I have this machineand if I cannot set up to scan to folder or email it is a deal breaker. HELP!! Please?