I would try the SD card itself.
Type: Posts; User: glewisme
I would try the SD card itself.
Thanks all. I'm a Sharp tech but they send me to anything!!! LOL
I was wondering if someone would kindly share the drum counter reset procedure for the IR3320i ??
66-10 seen this quite often!!!!!!!!!!
Have you cleaned the one way bearings and shafts in the bypass feed section???? Also in SIM 7-1 turn off mis-feed detect and try it. If it jams it's mechanical if not it's more than likely a sensor...
I.D.S
Let me know how it worked out for you...
Actually access to the sensor is easy once the feed unit is removed. Flip it over and loosen the two anchor screws for the steel pf guide ( w/ white mylar) pivot it out of the way and there it is...
Removing the entire feed assembly isn't really too difficult. The top cover that houses all the sensors is the real problem. I get it to the point it's ready but there's just one spot that's hung up...
Has anyone torn one of theses down to be able to replace the SPPD3 sensor.??????? Doesn't look too fun at all.
Blackcat is more than likely spot on. I've seen it many times. Waste toner coil gets bound by toner stones causing the drive gear to skip.
Mark happens to me all the time, 1 way to alleviate it is to set the web to advance after every job is completed I forgot sim but it does help out on the customers that just don't get it!!!!!
So I have discovered !!! That's OK we're getting the cassette under warranty!!!
Hi all I have a FSC2626MFP the lift gears on the paper cassette has a couple of broken teeth .I cannot find the parts break down in the parts manual for the cassette only as a unit itself . I was...
Is your driver set to start printing immediately or to start printing after the entire job is spooled.?????
I do believe the newest firmware will allow you to enable SSL, so you can setup scan to email.
I have one 2615 in the field that only does it after running a job with heavy paper without setting machine t heavy paper settings!! May try this though!!!
Still cleaning up after others I see Mark!! LOL
Hey all, just wanted to let you all what I've found. I've had a customer call twice about loud noises when running envelopes and cover stock through the bypass. What I found is the customer failed to...
If I recall correctly it is the harness. Believe it or not as long as you remove the harness anchor points from the finisher it really isn't all that bad. Disconnect all connections and you can use...
Not sure if you fixed your issues but make sure the primary cleaning unit has no obstructions , or bound I have seen that cause what you're describing as well
You can also use. Part # CFRM-1425DS52 it the part # for the entire web assembly in the parts manual! Though they do cost more than the MX410WC
If you like the Crawford tool ones you can use a propane torch and rapidly heat the hook then quickly cool the springhook in warm to hot water. This will greatly harden the metal, though it will make...
Turn off the jam detection in sim 7-1 if it passes paper fine you know it's a sensor issue. More than likely the PPD1 sensor in the PS unit is dirty or failed if it stops at the registration roller
Think of the drop in crime especially in the southwest if Mary J was legalized. What Mexican cartels. Hell everyone would have a basement grow lab!
I don't partake in it unless totally wrecked ( drunk) but I have no issues with it. I would if the smell didn't bother me. Truth is I think it's harmless!