Hello,
Need service manual for Oce 9400
Type: Posts; User: TzALbg
Hello,
Need service manual for Oce 9400
Hello Everyone
Does someone have dump for Lexmark X560n Transfer Belt Unit CRUM.
Thanks in advance
My opinion is bad charge corotron or dirty
It's dufferent method to upgrade reload NC software .
You have to have GSN and PWS tools
Altboot is like DC555 not like 2240! There is 3 altboot files
Yes toner is the same 1146 is in bigger bottle
for the first time clean IBT belt patch
Just reinstall or upgrade downgrade system software
yes GUI replacement
It is ussual problem with yhis mashine .
Touch in not spared have to replace whole assembly
yes it have. there is button Searchable PDF in file format menu
check and replace if necesery fuser fan
Disconnect finisher and Shorten DB15-3,11,13 pins and write again about faults
It is better to place this R away with two wires . In 45/55 mashines it is 5 Watt and not on CCD PWB
130 Om
CCD PWB must be replaced or repaired.
There is in the rear top corner big smd resistor.
It have to be changed
4-361 Check the Y-M-C CRU's
4-363 Check the K CRU.
Turn the gear in a clockwise direction as viewed from the gear (rear) side of the CRU.
If the gear binds or is hard to turn replace the...
1. Enter diagnostics
2. Enter DC131 (NVM Read/Write)
3. Enter 03 Machine Run Control and change the following locations.
set 3-005
set 3-018
Install Phase incopleted
Yes it is possible
Software incompatibility: software version of new MCU PWB doesn't match to software of the machine.
Reload Software
Try to replace
007K08262 Gear (24/35T)
The black ink cartridge is full to half empty every time I show up. Resetting the two NVM locations in the 09-357 RAP fixes the problem temporarily.
Replaced the Black Toner Cartridge Housing PL...
109R00334 fuser 460
109R00519 fuser DP90
other consumabler is the same donor roll and developer housing is different too
Check all interlocks carefully
check ozone filter anf fuser fan
read carefully administration guide