Has anyone experienced a massive static problem on the C1070. When copies exit the machine everything appears fine but as the prints stack on top of each other they become stuck together with static....
Type: Posts; User: faultman
Has anyone experienced a massive static problem on the C1070. When copies exit the machine everything appears fine but as the prints stack on top of each other they become stuck together with static....
i had three of these fail yesterday :-(
i'm told the latest f/w does not fix the boot up/cycling issue.......but something is on its way
are other techs at least seeing this fault....even if they dont know a cure. Then at least I know i'm not alone ;)
Hello
I am seeing a number of these little printers with the following code C0096, Does anyone have any fixes or tips to help. The transfer belt has been swopped and the machine just constantly...
Thanks for the information, the cable you talk about.... Is it the one that looks a bit like a USB cable. Is it usually just this part that causes the fault code.
thank you
Hello guys
anybody come across this fault code with the dual scan document feeder, any information would be appreciated.
thank you
anyone seen this code on a FS-534 attached to a C654. FW at G00-70, changed photosensor PS5.......any solutions???
thanks, in advance :confused:
Was this fault ever resolved? I have a machine doing a very similar fault.....any ideas fellow techs!!
Hello Guys
really struggling with a C554 thats jamming j99-01 and j32-05 every few copies, its on latest firmware and is doing it from all trays....anybody have any ideas
thank you
when replacing the feed assembly all feed rubbers/roller and clutches are included within the assembly.....machine lasted two days before customer booked the machine back in for jamming again
Hello
Having problems with a C284 giving random J2001 jams from tray 2. The machine is on version 68 firmware and tray1 & 2 feed assembly has been changed for this jamming issue but the problem...
hi
i have a c650 showing a constant j13 with no paper to be found, the only way to clear the jam is full reboot of the machine. Once rebooted the machine comes to ready to copy and works fine from...
Hi
does anybody have any ideas on a intermittent J15-01 jam codes on the C280 range when feeding from the LCC (PC-408). We have tried various things including motors and LCC control board and...
Hi
can anyone offer any advice on this one please, i have a bz950 continually jamming under the drum (j31) during copy runs on the second side. Sometimes the paper will have worked its way between...
hello
also have the same fault as above, tried whats been suggested. Mine just appear to be saying "warming up" with no error code. when you remove the finisher the machine works fine. Any further...
a new t/roller can really help with this jam code.....they usually get reset and never replaced as they dont come with the t/belt
think i had this once before when the pin had broken away the inside of the plastic gear (think it was item 19 or 15). This causes loss of drive to the feed, the gear just spins because the moulding...
any further news on j15-01 from pc-408 on a c280 model??? Seeing this code more and more!!! is it defo the sensor?
different motors and board, as discussed earlier sorts it out!!!! Tested on two machines now.
any updates on this fault...i have two machines with this fault, both jamming intermittantly but frequent enough to annoy the operators. i have done most things listed in this thread but i'm not...