Search:

I had this problem on a little ricoh 201....configured the machine in the shop using web image monitor....took it out to the customers site and couldn't access it. Checked all the sp mode settings...

Here is the procedure to enable user code access. Each user will have to be entered into the address book along with there given user code....also needs to be entered into there print driver if you...

Worn out drum and dev.

Yes yahoo is now exclusively using SSL encryption.....which means most all ricohs except for the newest will not be able to scan to email using a yahoo account. Check out gmx email. It is a free...

Yes I have swapped out the whole ITB unit....just swapped the grey handles so the colors would match....I am sure if you just wanted to the swap the belt alone it would work fine.
-C

Dirty paper feed clutch / registration clutch?
-C

If they have a track record like that....make sure they have a check ready upon arrival....I get cranky too if I don't get paid :)
-C

I don't believe anything has to be done to make this work...the appropriate corner should be beveled on the connector and you don't have to swap the wires if your using it for black. Just compare...

You can make a B2242042 work.
-C

Definitely could be a logic problem if it lets you duplex using the by-pass.
-C

I'm assuming you have cleaned all the ID sensors and ran line position adjustment. Getting it back to factory default would involve doing a memory clear and re-entering sp mode data from birth...

This particular model will jam if the slit glass is not in its proper position.....jam jam jam......If someone cleans the optics and doesn't get the slit glass back into its proper position (able to...

AB010368

Just take out the image transfer belt, black drum and magenta drum to give you room...the gear is held on by an e-clip...does this machine have a high copy count? has the development unit been...

I have seen the dev drive gear (behind each drum) get worn down and not properly churn toner into the developer too.
-C

I appreciate all the replies and help....It was the pressure roller. The fuser belt looked good along with all the bushings and bearings. The pressure roller had some lines and small wrinkling on...

That was my initial thought...didn't make a difference...haven't tried thick paper...customer never runs it so didn't even think to.

I have attached a few more examples of what it looks like in color...I have removed the laser shutter....I could see where a messed up pressure roller could cause uneven fusing but it troubles me...

I can see where you think it might be the fuser from my attachment. Its all properly fused and I get no repeat image. Fuser entrance guides are clean as is the fuser belt. Thanks manual guy I...

Hopefully someone has seen this before....my initial thoughts was a transfer roller problem...replaced it...still there.

Here is what I have done so far: swapped out image transfer belt and...

I have used this adapter on many Ricoh's with no problems...it does take up the ethernet port and the speed difference is not noticeable with normal print jobs...this is dependent on their wireless...

Hmm I haven't seen that type of dust on the machines we service...normally just regular brown dust...not plastic residue. Makes me think some sort of bushing is worn out letting that flag travel to...

I second that....if your lucky its just a dirty sensor......more times than not toner gets stuck in there like cement...I could see the coil getting in such a bind that it causes issues with the...

Is this an original ACC page?! we must get to the bottom of this if so...replace all mirrors in scanner and user a scissor jack to adjust a twisted frame!

Streaks like this from the charge roller can clean themselves up...it is largely dependent on what the customer is running. If they are making lots of high coverage copies the toner disposal system...