HI,
I have an urgent need for parts catalog and service manual. TNX
Type: Posts; User: zoran.riko
HI,
I have an urgent need for parts catalog and service manual. TNX
HI,
Brand new machine, after instalation start to give "Front Cover open" and than we replace the MCU board and now giving us SC 211-3 some problem related to carriage error. In the service manual...
TNX for trying to help me. I replace the switch-es, chek the cabless ( harness ) with instrument, then short-wire directly to the pins of the board and still the same sympthoms: Close Front Cover....
HI, On a NEW MP CW2200SP after 4-6 prints after instalation, the mashine give me an paper jam and after removing paper still stays CLOSE FRONT DOOR. I chek the left and right switches with instrument...
The only way if You can`t enter with user "supervisor" and blank for password is to replace the NVRAM.
Hi, Can anyone tell me How can I reset supervisor login and pasword because someone change the default login for supervisor and I can t log on into menu.Thanks,
I find from my friends from Zagreb
Hi Everyone, I need language file for AF 2090 ( *.fwl ).
TNX,
TNX for answering on My thread, I replace the fuser fan and now is working fine. Thanks a lot.
Thanks on quick reply, I am almost shure that the fan is the problem. Thanks again
HI,
I can`t find in manual what SC 530 means so, I replace the whole set of termofuses and termistors and still after few seconds showing SC 530. The fusing lamps are working and they are OK. Any...
the two waste toner bottles are empty, what to chek for this SC ?
I found .fwu lang firmware. TNX
Hello,
Can anyone give me a language file for Aficio 5560 color. I haven`t access to TESSA.
Thanks,
Yes, entire controler ( complete right rear "door" ), PSU + I/O board from another machine and still have same result....
Thank You for reply, byt as I wrote, the whole controller board was changed with other one, but the result is the same..
HI !
When the machine was in printing (working) mode, the operator guy switched off the power switch of the building. After that hi remove paper jams and turn the machine ON but "PLEASE WAIT" is...
Now I understend that the customer uses Domino for mail and LDAP, so they aren`t using windows Server platforms. For the reason why the machine can not read the LDAP server directory, ( Canon and...
The customer use SMTP Server
I tried to set-up scan to e-mail on this machine but without any result. IP, Gateway, DNS setings a OK. In local LAN exists a mail server, LDAP server, but I can`t list the directory, the other Canon...
Can someone tell me how to reset this error ( the fusser unit is cheked and OK ) or give me link for service manual. I can change that manual for one or two for Ricoh.
PLS help :(:confused:
With or without them every powering up except the code B-section is blinking. Also in output chek I can only put two solenoids on chek and sensors. The S17 sensor is showing 0 or 1 depends on cover...
I tried but everythung looks fine.
Other suggestions PLS ?
I replace the interlock switch with another but still get the same code: BK-156
Any suggestions, PLS ?
I need a language ( en ) file for MP1350 , don`t have TESSA support. Can anyone send me?