Just had the same problem last week. Installed latest system software version. 2 and new hard drive and all has been well.
Type: Posts; User: Itsthepaper
Just had the same problem last week. Installed latest system software version. 2 and new hard drive and all has been well.
When roll runs out during print job, I don't seem to find a way to perform a clean cut on lead edge of the new roll.
Need some help testing an issue, Bizhub 754E while its processing a print job mainly a big job if you go into scan mode the machine has a message that says "know scanning or know copying". While this...
We put a out a new C1060 and it's been a little tricky to say the least.
1. Right out the box the SOB jams on plain letter paper with full coverage every time.
2. Poor transfer on 2nd side...
12pt gloss about 270gsm, only on second side trail edge transfer is poor. Some sheets come out good but most have the issue, anybody run into this? :cool:
BLAH BLAH BLAH BLAH....don't waste your breaths fellow Americans. Until we take the money out of political campaigns nothing's going to change. Democrat, Republicans, Libertarian same old crooks...
What's more confusing is that it only does it at the customer's site. At our shop it worked fine for 2 weeks but when we take it back to the customer as soon as the network cable is plugged !!BOOM!!...
Yep, those lines are common when a step was missed in setup. When entering date and times in different areas of set up make sure to clear the current date and time even if it's correct, then...
I'm familiar with C500-C7000 pm kits, but unfortunately my dealer is rushing a C1060 out before I could get trained. Taking a quick glance at the manual and liked the replacement cycle for some of...
20649
Here you go sir.
You have to get threw the network before getting to the copier. I always advise customers to seek the help of a good IT company to lock down there network and secure it.
I have a C6000 that has a jam condition, machine wants me to open front door and open M5/M6 doors to clear paper, no paper present. Also no jam code is displayed in counter that shows a jam occured...
Did you take a look at the bulleting regarding J-9301 jam codes when duplexing? Check it out.
Well your gonna have to by a new belt anyways, make sure to put a new blade and put plenty of kaynard powder to lubricate the belt. Turn it by hand and make sure the belt turns without alot of...
"Still Printing Great - Just out of proportion" What is that suppose to mean? What is COGS?
Sounds like your a print shop, so it's probably "Operator Error" or "Its the paper".
Get a...
I would make sure the side door is not skewed, check the hinges. I did go to training on that machine and the door could cause problems with skew if it's not sitting straight on the machine.
I encounter similar issues when fax machine is hooked up to a voip fax line. Try turning ECM to OFF and set baud rate down to 9600. Do you know if fax line is digital or analog?
I'm going to replace the folding rollers and folding blade on and SD-508. Has any replaced the blade on a SD-508? I've searched in the manual but no dice, it looks really burried in there, every...
I told my field tech to clean the folding rollers when he 1st came up to me with this issue. If I go out there and that's what it is then my tech got lazy on me, I know those folding rollers could be...
I'm taking a shot in the dark and piont to the transfer belt, yellow transfer roller could be out of place or binding. DON'T Forget to do a new release so you could put the belt back in the box as...
Possible beltwalking or knick on belt, whenever I've come across this issue it's been one ofthe 2. Try reseating cleaning unit making sure to thoroughly dust the belt andcleaning blade.
Anybody, HEY GUYS!!