Search:

I'm looking for a xerox tech in the Tulsa, OK area to work on xerox wcp c2128. Anybody close?

Where did your order this part from?

PM?

Yes

Don't have diagnostic tools for these machine.

I replaced the battery. Same result. Goes through machine self test, but does not come on. Ask me to try restart. Removed same module from another machine and replaced non-functioning one and it came...

My XEROX S/W MODULE has failed. Does anyone know where to purchase one of these?

I don't have diagnostic tool. How can I get this. Just purchase this machine no software or service manual. Or is there another way to run dc 133 and 105?

No code, but I think I figured it out. Dead battery.

Upon power up message comes on screen "Communications error encountered". Don't have service manual for this machine, can anyone tell what causes this, and possible fix?

I have not been able to get the print calibration to complete on my C2128. Not sure what's causing this. Just comes back on screen "Calibration Unsuccessful." Anyone know how to correct this?

No. This machine was out of service. No copies made. Was working before it was replaced.

Copier will not start. Gives C9C error code. Anyone seen this before?

Color prints are covered with magenta toner. Replace cleaning blade, doctor blade okay, and seals seem to be okay. Is there another reason this could be happening.

Just got this copier, and this error code comes up. It only happen when finisher is connected. Don't have service manual. If anyone has one I would appreciate a copy. Any ideas?

I have two copiers/two issues:

1. On copier #1 I'm getting code C9C. Does anyone know what this means. It is not in the service manual. At the same time the copier shows a jam, but no paper.
...

Maybe someone can help me with this. 11 x 17 paper of any weight continues to jam in my finisher. The leading edge will not exit. I replaced the PC board, but it had no effect. Is there another...

Never seen this before. Anyone have any ideas what this is? Also have another machine that is toning in magenta on the entire print. I have change cleaning blade and reinitialized, but no change. Any...

I have replace the registration motor and sensors, but still have deiviation in prints. Anyone have any ideas on how to correct this.:confused:

I just replaced charger wire and grids on EPU unit. Now the cyan density is low. I reiniatialized the auto toner sensors and ran a gamma adjustment. No change. I'm also looking for a saddlesticth...

When printing or copying, I get dull lines in areas where there are solids. Can't see them if print is small coverage. I have changed cleaning blades and chargers shows up mostly in cyan and yellow...

Toshiba e-studio 310c

When I print out copies with a lot of coverage it jams in the fuser, and also knocks out my Separater Guide and exit roller unit. Is there a way to remedy this?

Okay got it! Would this also cause poor image quality? Now there is little to no image. Just outlines of image.

Check everything in the service manual, still getting this error. Any other ideas?