Search:

forgot my mail : vaclavborc@seznam.cz

can anyone send me service manual SD-509 ,
every versions , i have only A10D

I have 1 printer and 5 imaging units ( 90 % life) . Used IU does not reset conter in nachine.

is posible to reset drum counter without replacing new imaging unit?

thanks

can you anyone sed me program for reset waste ink for canon mp (not mpc) 190 if i make usual procedure for enter service mode and reset it, doesnot work.power+cancel, 2 x cancel, 4x cancel ...

I am in service mode and i see displaying "0" but when i press stop/reset button 4x time i can't see change on lamp. I cycle the power but E27 continue to display.

Thx oze on help

After power on , display shows "hp" and starts initialize, after 5s display shuts down
and plotter turns off and on it selfs.Then again and again.......

thanks for help

How to reset imaging unit counter /without replacing it?/

thanks for details

My printer moves every images 1 cm right.

is there any NVRAM RESET or what to do?

Hi , I have problem :

toner density too low , Is there service code for adjusting print density.

How to enter service mode , how to adjust toner density?
thanks

hi , please can you tell me how much of copies can work PCU unit aficio 2018 .
My PCU did 40 000 k . Can it work 60 ?

2 right key 6 right key 2 right key 7 right key 3

can you anyone send me service manual magicolor 1680mf . thanks

vaclavborc@seznam.cz

After I replaced fuser unit , printer indicates E0500 / fuser error/.

Is there any reset for service codes.

/stop 0 stop 1/

STOP AUTO EXPOSURE /second buton/ STOP ZOOM SELECT/fifth buton/

HP LJ 2015

when turn on machine , the 'paper jam message' light on on it´s control panel.

There is not any jamed paper. All paper jam sensors are ok.
And motor turns on,when open and close...

Please who can help, how to adjust auto exposure lighter.

please can you tell me how to reset DRUM LIFE counter
without replace new drum?.

(DR 6000)

many thanks for help . Drum prints well

what means service code E0066

I have not service manual and my customer told me
to repair it.

thanks

Machine indicates "wrong scaner lamp".

May it be wrong firmware?
Where to download firmware?

thank very much

Thanks , but customer pay for reset this warning.

I need reset drum conunter without replace drum !!!

How to reset " drum warning"

I do not want replace drum.

Some service code?

many thanks

When printer displays "processing job" and halts for
obout 2 minutes, then prints the document.

When print config.page, printer prints " firmware error",
but firmware was upgraded.

The printer halts on " processing job" .