Thank you SIR
Type: Posts; User: jaybug
Thank you SIR
Looking for a part number for the coin vender interface. The connector on the board is different from previous models so it's not going to work. Any help would be much appreciated.
#2 Forbiden Planet
yea what he said
Good Luck. Usually on backorder for a while
Try Precision Roller or Parrott Dist.
Don't you have to do a LBP fuser reset for a E4-02 also after you remove the jam.
^^^^^^^ what he said
LVPS or SPC ???? sounds expensive could be power at outlet
check the front gear on the drum (the one that drives the transfer roller) I've had those slip and cause all kind of wierd jamming and CQ problems
What model?
check F5-42 it should be set to 1 key counter installed
what about the white gear on the front of the lift motor (the one that meshes with the tray) is it not freely moving back and forth on its shaft? or it could be broken .
Translate into English please.
cyan laser error.
1. LSU is defective.
2. EC PCB is defective.
3. LSU - EC PCB Harness is defective.
4. LSU or EC PCB connector is disconnected
MEK Methyl Ethyl Ketone for selecsol substitute
Simple Green Cleaner for most everything else
what are you wanting to clean?
rubber ?
plastic ?
metal ?
Glass ?
your clothes ?
you will probably have to replace the hot roller also. they wear fast. PN hot roller DZLA000286 web roller FFPKM0344.
even our "newbie" tech changed both without some one holding his hand.
I'm looking for the part number for the service manual to a Lexmark T-640.
any help would be appreciated.
take hammer wack hole in toner box. pour in new toner. seal hole with gorilla tape.
check your door switches
I am looking for a SC PCB for a Panasonic DP-3030 part # PJWPF2741PU
Any body got one?
eight zeros
have you checked for pinched wires. could be the fanspeed feedback wire grounding.
check ADF sensors {length and width} in F-4