thanks for the reply. it's not setting problem. I could see the finisher, booklet and centre staple. even after selecting all the right settings it was not working.
thanks
Type: Posts; User: brij
thanks for the reply. it's not setting problem. I could see the finisher, booklet and centre staple. even after selecting all the right settings it was not working.
thanks
hi
full Memory cear is 5801 in service mode not 5882. sc 995 is the serial number error. you have to enter the serial number of the machine manually I think it's 5811. normally it's come after...
Hi
I don't know konica machines but I think you should set the machine to original settings and than think about what you did to scanner and try to recitfy that.
It's been a while now I have not worked on that but check the drive for cyan dev. Is it through a clutch ??
Hi
I am assuming that you are not printing on thick paper with normal setting. normally ghosting is caused by fuser not fusing properly but in your case it cutting the prints also so i will say...
Hi All,
I had a problem printing booklet from MS publisher on a RICOH MP9001 using a shared driver(win2003 sp2) . they had Af2075 before which was working fine. I removed the old drivers as I had...
carrying a box of blank dvds is a good idea. also virtual mac and win 08 server ca be a good help on site. cable tester
hi It normally comes from PtR section. code is for ID sensor but actually nothing to do with that. Its arcing somewhere in PTR section.. remove and check the bottom plates for bent or damage..
go to service mode and do RAM clear.
how old is the developer. try new developer. it might be from td sensor.
clean the mag roller and replace the developer. enjoy