You need to access the preboot menu of the machine and perform a cold reset under administration menu and startup options. If that does not work there is a partial clean option but that will clear...
Type: Posts; User: Elmo
You need to access the preboot menu of the machine and perform a cold reset under administration menu and startup options. If that does not work there is a partial clean option but that will clear...
turn off IEEE auth and try
Try user name supervisor leave password blank
this would give you access to admin so you can change the admin password
I was lucky to have it in a workshop with a spare machine to allow me to test the boards in
once i knew they where good it had to be a something within the machine removing connectors 1 by 1 from...
Turned out to be the bypass pickup solenoid pulling down voltage
strange how it made the language into Japanese once solenoid was disconnected machine loaded ok and in English
part replace now...
Voltage at IOB's seem ok
So decided to try all boards 1 by 1 in working machine
all ok put controller BICU cage in was able to update firmware get into service and change language all ok
so put...
Thanks for the info Luca
When i swapped the whole Controller, BICU Cage i left the NV Rams in it so i know they are good (from a working machine)
i tested it with all units out and options...
Hi
I have an IMC5500 that wont play nicely
When powering up no motors or scanner movement
Has SC665-08
Go into service Language is in Japanese
Select System sp list shows but then screen...
Could it be someone has replaced the ssd with a used 1 from a doner machine and not followed the procedure properly
thus bringing the mac address from the doner machine with it ?
you may have optional software installed
goto user tools extended features and look if you have you may need to be logged in as admin to uninstall them
you can use a wifi extender then ethernet cable from it to copier.
This machine does not have built in wifi
you would need to fit the optional wifi kit
What type of wifi device have you connected to the copier ?
Very odd but had a trade in MPC307 come in this morning with very similar fault screen showing preparing to update firmware
solution was to install older version of Engine and System firmware (2018)...
Fit a new HDD and try firmware tool again
Also try put the screen into android recovery mode and reset all data
Thanks Venom
Your advise helped turned out to be the optics unit faulty
possibly caused by the staple on the controller pba
stripped and cleaned optics and adjusted still same
replaced the...
was an odd fault
when copying colour or b/w on the glass worked fine
when copying b/w thru adf worked fine
Error only occurred when copying colour thru the adf
Turned out to be a staple on...
E302-0003-04 Error in paper front white shading
Detection Description The paper front white shading value gradually became out of the specified range.
Remedy [Related parts]
- Harness between the...
Hi All
on a batch of ex lease machines i have 1 with a fault it is low mileage sub 50K
when copying via the document feeder i get e302-0003 code
i have tested a different feeder and updated...
PM'd you instructions
Have you tried Factory resetting the sop screen in android mode
Service mode can be locked in Admin settings
Hi
Could anyone help with a part number for C300i SSD 256 Phison or possibly a parts manual
Thanks
hold down 2 and 8 then switch on it should set the machine to 172.16.1.100
use a cross over and set you pc to 176.16.1.101
You dont need the firmware to recover the machine if it has had the HDD removed and you are getting E602 error
replace the missing HDD with the correct type Toshiba MQ01ABF032 320gb
connect to the...
try ebay
Postscript 3 unit
Type C2551
D5565004B
Although i usually found using a different pdf software ie Foxit helped more than the PS3 Card
The Cards have protection so are difficult...