I replaced the entire upper fuser, which means all of the parts you mentioned are new. Yes, it heats up. I said in my previous
post that it went up to 212 C. I replaced the DC controller today. Now...
Type: Posts; User: milldew
I replaced the entire upper fuser, which means all of the parts you mentioned are new. Yes, it heats up. I said in my previous
post that it went up to 212 C. I replaced the DC controller today. Now...
OK, troubleshooting section, my bad. Going for the DC controller next. The SSR is mentioned in the back
section on error codes.
In the service manual for the E003 it suggests replacing the SSR, but.... after searching and searching through the
parts manual there is no SSR to be found, anywhere. Is it part of the power supply...
I'm having the same problem with Taskalfa 620, have changed shitchback roller and a few sensors to no avail. It is intermittent now, Jam 65 every time.
The paper always comes through switchback and...
Since i have to drive 80 miles to do it, I'm taking the whole kit. I wish Kyocera would get it together with their terminology.
I just ordered the MK-132, it only costs a little more than the drum. Thanks all
But... what is the 'process unit'? The drum unit or the developer unit? I sifted through the ops manual and the service manual... nothing about process unit other than how to take out what appears to...
Replaced dvs and problem solved, one was tight apparently. End of thread, thanks all for help on this.
I will try turning on the heaters, thanks for the thought. I am also going to swap the job separator to see if any effect.
Jam 51 occurs first copy or print of the day, they clear it and it doesn't jam the rest of the day. I have replaced the exit unit, blown out the job separator.
c2102 code, seems to happen at first turn on in the morning, they clear it and will run all day or sometimes will code a few times a day, always resets and runs. The manual says CMY dv motor or drive...
First guess, main charging. Just a gut feeling. I did see a bulletin on the contacts in the door that mate up to the machine for the transfer, but I think that would cause voids mainly. Swap the main...
Seeking an Office Equipment Technician/Apprentice for repair and maintenance of copiers, printers, fax machines. Strong computer skills needed, some networking knowledge helpful. Must have excellent...
Actually we can get a refurb from Kyocera for about $400, but still, wow. Is this thing made of gold or what??!!
Need a working print board for a Kyocera KM-C3232 or 4035, email or call 406-234-0450 ext 234, Roger
We have a lot of ink and masters we can't sell because all the old machines in our area are dead and gone. We would be willing to sell it at 70% of cost. Anyone out there interested, email me.
Your welcome, I just worked on a 1010 today, oddly enough. We have several machines parted out, and as far as I know Canon still has parts available.
PS- just checked on Canon, only a few parts...
I had the same sound you described one time, turned out to be the fuser lower bushings. Hmm fixing cleaning mode, good tip. I have had hard drives make similar sounds before they died also.
Check the interlock switch on the fuser door. Its just a piece of flat metal that can bend and not actuate the switch, front side of door. Also check the main interlock, less likely that one. Either...
to reset the web counter you must press the service switch (inside the little hole in the front panel), and the clear key at the same time
I have 8 years experience with Canon and 5 with Kyocera, and a lot of certs. I also have been doing pc repair and networking since 2000. Just wonder what it would take to relocate to Canada from the...
I run a 2 man shop, and never really had some decent software to track service calls , meter count, service contracts and such. My company owner wants more accurate profit reports, our current RMS...