Don't bother with the parts, Everyone is trying to save the company money!!!
Type: Posts; User: bob scheffer
Don't bother with the parts, Everyone is trying to save the company money!!!
it was probably the hole punch but i have had to clean the rollers in the inverter as the paper comes out and that fixed two of mine with the same problem.
I would replace the feed clutch, relay clutch, and reg clutch as a set. If that didnt work, then i would replace the sensor.
That is a problem with with the tray lifting operation when you set the originals. you put them in and it doesnt lift or it does lift and the upper sensor does not see the tab on the pickup/feed...
i had one with the toner save mode was on as well.
what jam code does the machine log on the SMC report? SP5990 then select "logging data" and print it out. that will show the "jam codes" and i might be of more assistance! :D
yes, handle part# is B0903605, and the toner supply ubits are the same B0273501.
Toner pump motor failed at first (began with under-toning ironically enough). since then, we have replaced dev unit, drum unit frame (this includes id sensor and potential sensor as you probablly...
I agree with teebee1235 100%, or you might try a main board or nv ram.
oh lordy! its been avery long time ago but here goes nothing. Enter sp modes press clear modes, 1,0,7, then press and hold clear stop for 5 seconds. press auto image density button press 9,7 then...
Bulleton #2 has new style brackets for the thermistors (part # D0624196 and D0624197)... The new style brackets have an "O" written on them from ricoh. supposedly their shape has been changed to...
Replace toner supply (part # B0823208) or the internal part with the mylars (part # A2323240) which is even cheaper!
:mad:1357ex dumping excess toner
We have two 1357ex's overtoning 1st machine has 1,400,000 copies customer runs appox 20,000 duplex copies a day mostly 8.5x14 1st page full page text second...
Tech support just told me the engineers in japan are aware of the problem and are trying to resolve it. Design issue.
not yet but that is going to be next if the customer calls back.
actually i only tested tray one which was 8.5x11 but it did it whether it was portrait or landscape.
so far i have replaced fuser, reduced fusing temperature, adjust fuser entry guide lower, increase buckle from duplexer and removed a magnet and catch plate (which is on the back side of the transfer...
I have seen this exact same problem with regular 20lb. paper about three times. The paper stalls as it attempts to enter the "nip" of the exit rollers. i repaired all 3 of these by taking out the...
We have Toyota Matrixes that are painted with bright red logos all over the car. The cars run very well and hold a huge amount of parts and are reasonably comfortable. The best part is not having to...
the paper curl is a function of humidity and the direction of the grain of paper. i have had no sucess (nor did anyone else ive talked to in 23 years of doing this) by adjusting the copier fusing...
Solution Text
Software error - if it will not clear try NVRAM all clear.
Software error - isolate components to check for a pinched wire causing code
Software error - w/filename eng:procon.c...
Hi Tim! I think you told me about this site so i thought i would check it out. its GREAT!
the previous cryptic looking symptom/cause list i just sent all apply to savin 2535.
Problem Desc
Solution Text
DEAD MACHINE, NO OPERATION
[dead machine] - Replace Controller PCB
DEAD MACHINE, NO OPERATION
SP5832-1 is reformat all! I hate this code! Might need a new hard drive and definately re flash the firmware. A bad drum will cause it if the surface is worn through to the aluminum substrate, but i...