update from me.....it was the psu (not sure if ac or dc board) both changed. the guide in the service manual is for the garbage
Type: Posts; User: hanspeter75
update from me.....it was the psu (not sure if ac or dc board) both changed. the guide in the service manual is for the garbage
i also have this problem on a mpc3004ex. ipu / bcu and cable to the scanner changed...no success. must now the oru (scannerunit complete) be replaced or is there another solution?
If it is a PB3160 then replace ax040273 (DC MOTOR:RISINGTRAY:ASS'Y:1.007) CHF 41.70
bicu was faulty :mad::mad:
Hello together
Have the problem with this SC code. The error always comes when starting the device. Scanner does not initialize and the lamp does not turn on. Motor / scanner completely and the...
hello and thank you for the answers
Yes, I know the problems with the broken spring by the older mfp`s. But here it seems to be a general problem ( in the parts catalog it has no springs) the stops...
I have several of these devices standing here and all make slightly slanted prints / copies from the cassette (about 2mm LEF) feed roller / pads already changed .....no success. An idea ev to this,...
do you mean this one?
I do not quite understand?
@slimslob sr3220
yeh....i do order the 2 motors and the wire.
I hope it helps...let me know then
this error exists temporarily at the sorter. where is this motor on the parts catalog...? another idea what else could it be?
gruss
the problem seems to be solved after 1 week test run with a new replacement heater. the first one was "new defect" ...no idea why
'm not changing the nc sensors on a new station... they should work
fuser now replaced with a complete used unit...now works
will then test the existing new unit with the nc-sensors when they are...
fuser station complete revises no success, new fuser station ok but several times a day sc541-02 (NC sensor interrupted)
Wiring harnesses checked and replugged...no way
an idea before I replace bcu...
d1751357
try a sd-card with all firmware for the MPC305.... i mean 10-15 files.
Hi
Could you solve the problem....same here with a spc262sf?
hello
What is the default password for the admin account and how can I delete an existing one? :confused:
hi
Easier away for (all) SD-Cards....put in in slot 2...then on panel systemsetting,admintools,backuptools addressbook,format.....and you have a function sd-card.
greets
I remember .... 2 months ago same problem. The easiest way off only the shaft with gear and bearing monies ..... then the clutch. I wish you success
hdd in heaven.....
Be sure the latest FW install for the Finisher......02.340:10
fixes many bugs
...or renew java if installed.
ADF liftsensor? do you mean the ADF open or close Sensor...looks good, the flag goes inside.
Hi
both replaced ... no success :confused: